16
General Discussion / Re: 1968 L89
« on: June 02, 2023, 09:52:59 PM »
Think I'm droolin', Ed, but don't stop there! lol OE drivetrain ?, colors ?, photo's ?, etc.... 
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
17
General Discussion / Re: 1968 L89
« on: June 02, 2023, 09:12:04 PM »September, 1967
Ed
What else do you know about that particular car, Ed ??
18
General Discussion / Re: Original 68 dash pad?
« on: May 02, 2023, 05:23:47 AM »
LOL...Watch it Cook! I like yur cat.
19
General Discussion / Re: Lee’s Car
« on: April 30, 2023, 09:19:39 PM »
A couple notes regarding your post 16, which I'm finding quite interesting, btw.
Generally, no ME coded small block (327) got a partial VIN stamp in 67. Federal requirements began in 68.
Hand painted pinstripes were included on all 67 Z21 and Z22 equipped Camaros.
PTB stamps could probably be seen with the fenders removed.
Would really like to see the trunk!
I'm guessing the entire bottom side was undercoated, including the gas tank straps (prior to the tank being replaced).
Generally, no ME coded small block (327) got a partial VIN stamp in 67. Federal requirements began in 68.
Hand painted pinstripes were included on all 67 Z21 and Z22 equipped Camaros.
PTB stamps could probably be seen with the fenders removed.
Would really like to see the trunk!
I'm guessing the entire bottom side was undercoated, including the gas tank straps (prior to the tank being replaced).
20
General Discussion / Re: Lee’s Car
« on: April 25, 2023, 11:44:12 PM »
Thanks Doc. Noticed the N34 steering wheel as well. N30 in the shippers report. Interesting car to say the least. Keep the photos coming please....
Keep the photos coming please....
21
General Discussion / Re: Lee’s Car
« on: April 25, 2023, 09:38:20 PM »The floor mats are screwed in, as they were an experimental piece for possible future Corvette use. This is the original shipper’s report.
Who screwed the floor mats in?
B37 in the shippers report is the standard floor mat used in all First Gen's.
22
General Discussion / Re: 69 Z28 Rally wheel
« on: April 18, 2023, 08:45:58 PM »
4 1/4" bs, 5 x 4 3/4 bolt pattern.
The common FW code GM rally wheel is an exact match, dimensionally, as mentioned above.
The common FW code GM rally wheel is an exact match, dimensionally, as mentioned above.
23
Originality / Re: 69 door handles
« on: April 15, 2023, 09:13:48 PM »
Pics and a measurement or 2 would be nice...
Way back when, I had mine rechromed as a comparable repop didn't exist ....as far as I knew.
https://rpui.com/-Exterior-Body-1967-69-Chevrolet-Camaro-Pontiac-Firebird-Outside-Door-Handle-Assemblies-Pair-6735
Way back when, I had mine rechromed as a comparable repop didn't exist ....as far as I knew.
https://rpui.com/-Exterior-Body-1967-69-Chevrolet-Camaro-Pontiac-Firebird-Outside-Door-Handle-Assemblies-Pair-6735
26
Maintenance / Re: 1968 lighting/engine harness
« on: February 11, 2023, 11:25:54 PM »I have a 68 and it looks like it has 69 harness in it.
1 temp wire is on light harness not engine harness DG
2Blower motor wire is orange not purple
Could late 68s have 69 harnesses in them?
That's correct for all 68's, regardless of the build date. Purple goes to the starter solenoid.
27
General Discussion / Re: Pictures of 1st Generation Camaros at 2022 MCACN
« on: November 22, 2022, 05:00:16 AM »
Wow, I've never been there, but am quite surprised only 1 68 Camaro!? Maybe Chick scared all the competition away last year! lol
Thanks again, I appreciate the extra photos and the link.
Thanks again, I appreciate the extra photos and the link.
28
General Discussion / Re: Pictures of 1st Generation Camaros at 2022 MCACN
« on: November 22, 2022, 02:07:13 AM »
sigh....only one 68 worthy of A photo ? 
Any info on that particular car? I'm guessing L78...
Thanks for sharing!
Any info on that particular car? I'm guessing L78... Thanks for sharing!
29
General Discussion / Re: What's it worth??
« on: November 15, 2022, 10:09:33 PM »
Not entirely true. ZL2 could be ordered with any SS (not just pacecars) or Z28.
http://camaros.org/exterior.shtml#cowlhood
ZL2 could be ordered with any SS (not just pacecars) or Z28.http://camaros.org/exterior.shtml#cowlhood
30
Originality / Re: Smog Exhaust Manifold question 67 SS LOS
« on: November 08, 2022, 05:36:19 AM »Thanks!.
The motor is VIII4MV so they are about a month apart.
Ed, that brings up another question. Was it both the VIN and the engine ID numbers stamped on the engine at the same time? Or was it the engine ID at one time and the VIN when it was mated to the car?
Engine code was stamped at Flint or Tonawanda when the engine was built (assembly code). Partial VIN was stamped at Norwood or Van Nuys when the car was assembled, both on the engine and trans.