31
Maintenance / Re: Power steering issues
« on: January 26, 2016, 12:33:07 AM »
this is a original 67, L48 with standard tires.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
32
Maintenance / Re: Power steering issues
« on: January 24, 2016, 10:41:33 PM »
If you would it be great Steve. I'm hoping that it's a weak relief valve. Around what pressures should it run?
33
Maintenance / Power steering issues
« on: January 24, 2016, 06:35:33 PM »
Have issues with lost power assist after car warms up. Power steering will work fine most of the time till engine compartment is warm. I'll pull in a lot and at low or revved rm cannot gain assist back. Belt is tight and fluid ok. The relief seems to bypass a little quicker than most to me. Would check pressure but not sure what is is suppose to be. Any suggestions?
35
General Discussion / Re: 67 Cruise Control Information
« on: December 21, 2015, 02:14:55 AM »
Kid,
Search K30 clip and it will take you to pics.
Brad
Search K30 clip and it will take you to pics.
Brad
36
General Discussion / Re: 67 Cruise Control Information
« on: December 21, 2015, 01:55:22 AM »
Have a survivor with cruise. Have published a pic of clip on here
37
Originality / Re: What is correct "grey tip" oil dipstick for 1968 small blocks?
« on: December 20, 2015, 02:33:06 AM »
Dave would you mind adding a pick of yours to this thread?
38
Originality / Re: What is correct "grey tip" oil dipstick for 1968 small blocks?
« on: December 20, 2015, 01:48:22 AM »
I have been attempting to find out what was right. This was said to be a service replacement. But how was that when nobody could tell me or really knew what was orig.
Thanks.
Thanks.
39
Originality / Re: What is correct "grey tip" oil dipstick for 1968 small blocks?
« on: December 20, 2015, 01:22:55 AM »
dave this is the south end of 67 stick
40
Originality / Re: What is correct "grey tip" oil dipstick for 1968 small blocks?
« on: December 20, 2015, 12:39:30 AM »
Yes. It's a L48 survivor.
41
Originality / Re: What is correct "grey tip" oil dipstick for 1968 small blocks?
« on: December 19, 2015, 08:18:10 PM »
Mine is the flattened curve, no dimple, has the E and low mark, but is what seems to be a brown ? button.
42
Originality / Re: What is correct "grey tip" oil dipstick for 1968 small blocks?
« on: December 19, 2015, 02:29:43 PM »
So again I Ask does anybody have pics of or know what is correct for 67 SB's? Like a L48?
43
Decoding/Numbers / Re: Sheetmetal, Decklid code stamping
« on: November 21, 2015, 09:06:23 PM »
you are taking about this area on left side being for the Pontiac lettering Correct?
44
Decoding/Numbers / Re: Sheetmetal, Decklid code stamping
« on: November 21, 2015, 08:44:15 PM »
might explain the VM2 code hu?
45
Decoding/Numbers / Re: Sheetmetal, Decklid code stamping
« on: November 21, 2015, 02:06:00 PM »
one of the best pics I can get of it. My only real question at this point would be is it a GM ?