Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 69Zlemansblue

Pages: 1 [2]
16
General Discussion / Re: anyone use the HAys 85-103 clutch assy for Z28?
« on: August 07, 2009, 02:43:05 AM »
I've used a Hays 55111 disk & 51105 plate from 1980 to 2008. It finally wore out, so I put a new set in. Hopefully I can get another 28 years out of this one too. I think you can't go wrong with the 85-103. BTW, mine never chattered.

17
Originality / Re: correct shifter for 1969
« on: July 24, 2009, 03:43:21 AM »
Yep I think I will call them and get some more info.

                            Thanks again, Rich

18
Originality / Re: correct shifter for 1969
« on: July 23, 2009, 02:01:00 AM »
Thanks for the reply bcmiller, I still would like to know the difference between the 3128 and 3138. There's a new Hurst shifter on Ebay # 190204119312 that has a 3128 offset shifter and doesn't have stop bolts on it. It has a regular handle on it also. They say it will fit, but I would like to be sure before I spend my hard earned cash.

                                                                                                                                                    Thanks, Rich

19
Originality / correct shifter for 1969
« on: July 22, 2009, 03:40:19 AM »
My original shifter is long gone, about 25 years ago I replaced it with a Hurst unit. I would like to put a close to original one back in. I have a console, so I need a good fit. I've seen two different shifter numbers. A 3128 and a 3138. Which one is correct and is there any difference between the two?

Thanks for any help on this, Rich

20
Test Drive / test
« on: July 02, 2009, 02:45:12 AM »
Just checking

Pages: 1 [2]
anything