Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - SS396

Pages: 1 2 3 [4]
46
General Discussion / Ignition buzzer and glove box installation
« on: October 04, 2010, 01:43:31 AM »
Did 68 Camaros have the ignition buzzer installed and if so was it all models. Is there any specific way to install glove box as mine wont go in. Do you have to remove the heater duct in front of console and come in from underneath?

47
General Discussion / 68 69 diff ratios
« on: June 05, 2010, 11:43:34 PM »
Does anybody know where I can find some info on what diff ratios were available for 68 - 69 camaros with 396 and turbo 400 trans.

48
Maintenance / No carbon in exhaust port of 396.
« on: March 17, 2010, 09:36:54 PM »
Bought a rebuilt 396 just recently but cant get it to run properly. There is no carbon in no. 8 cyl exhaust port whatsoever, clean as a whistle.Took rocker cover off to see if valves were opening and closing on that cylinder which they were so it has me stumped. I thought if the cyl wasnt firing you would still expect to see some residue or petrol in the port. Any ideas.

49
General Discussion / 68 Camaro Heater box
« on: February 21, 2010, 03:24:33 AM »
Was wondering if the inside dimensions of the heater box where the core sits is different between BB and SB. Went to fit a 68 BB core in my box and it seems to sit too high and I can't fit the clips on. My car runs a BB but was originally a SB.

50
General Discussion / 68 69 Subframes
« on: August 08, 2009, 11:25:13 AM »
Does anybody know for sure if 68 and 69 Camaro subframes are the same. If they are different can anybody tell me in what way.

51
General Discussion / BB 396 sits to low in 68 Camaro
« on: March 06, 2009, 12:23:07 PM »
I've put a 396 engine into a 68 Camaro using repo engine frame mounts purchased from classic industries. They are stamped with numbers 3912597L and 3912598R which are supposed to be correct. I'm using new original motor mounts 6258154 so I assumed everything was right. The problem is the motor sits way to low, the fan hits the bottom of the shroud and the front section of the sump nearly rests on the subframe. Has anybody got any ideas as it's driving me crazy. Something is wrong somewhere and I can't figure out why.

Pages: 1 2 3 [4]
anything