Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - heckler

Pages: [1] 2 3 ... 7
1
Maintenance / Re: Rebuild of Rochester 2BC on '67 Camaro
« on: July 22, 2010, 03:48:24 AM »
Thanks a lot Rick for spending your time on my topic...very helpful.

Let you know how it goes.

2
Maintenance / Re: Rebuild of Rochester 2BC on '67 Camaro
« on: July 21, 2010, 03:46:49 PM »
Also, what of the PCV.  It's a "screw" in?  No parts places have reference for it.  They all have reference for push in.  Is my part correct or is their references wrong?

Screws into carb....

3
Maintenance / Re: Rebuild of Rochester 2BC on '67 Camaro
« on: July 21, 2010, 04:10:59 AM »
Now rebuilt.....How do I tune it?  Obviously just adjusting idle screw is not all there is.  Any special tools or tricks?

Thanks!!!!!!!!

4
How can I find a model/part # without the tag usually mounted on front?

5
Decoding/Numbers / '67 camaro coupe, 327ci, 2B Carb., powerglide 2 SP
« on: July 20, 2010, 04:06:56 AM »
Carb. number in a circle on driver's side says....7013878

I assume it is Rochester as it has the raised letters....RP on top and side of carb.


What can I know about this carb.?

6
Maintenance / Re: Rebuild of Rochester 2BC on '67 Camaro
« on: July 20, 2010, 02:30:59 AM »
Awesome reply.  Great info. 

What did you mean by left/right picture?

And where might I get these parts?


7
Maintenance / Rebuild of Rochester 2BC on '67 Camaro
« on: July 17, 2010, 08:46:09 PM »
This is under the Idle Compensator plate.  Can anyone tell me what is missing?  I feel in a pervious build there were 2-3 other items under this plate.



8
Maintenance / Re: 67 CRANKCASE VENT TUBE (327ci)
« on: July 17, 2010, 08:41:22 PM »
That helps, thanks!

9
Originality / Oil filler next/breather
« on: July 17, 2010, 03:55:40 AM »
What color was the filler neck and breather cap for a '67 camaro 327 2BC LF7 motor?  Documented picture?

Thank you!!!!!!!!!!

10
Maintenance / Re: 67 CRANKCASE VENT TUBE (327ci)
« on: July 17, 2010, 03:20:43 AM »
Found a pic of my needs on pg.98 6 C5.  Exactly what I have.

Frustrating the ASM never shows a 327 210HP 2BC or LF7 engine.  Why is that?!?!?!?!?!

11
Maintenance / Re: 67 CRANKCASE VENT TUBE (327ci)
« on: July 16, 2010, 03:23:33 AM »
Will refer to manual.

And yes the canister was in the oil valley.  Any ideas on gaskets you mentioned for this part?  Can't seem to reference at any known parts places.

12
Maintenance / 67 CRANKCASE VENT TUBE (327ci)
« on: July 15, 2010, 02:30:37 AM »
The vent tube on the back of the block by distributor is being put back(was leaky).  Does anyone know if it was to have a gasket or RTV?

13
Originality / Re: Intake bolts different lengths? 67 camaro 327 w/AC
« on: July 14, 2010, 08:25:53 PM »
After cleaning off the tops I concur.  Lots of different bolts, 5 original to my observation.

They didn't have washers...did original setup have washers?

14
Originality / Intake bolts different lengths? 67 camaro 327 w/AC
« on: July 14, 2010, 04:29:59 PM »
Why are the manifold bolts I took off different sizes.  The two longest ones were on the passenger front and went through the bracket for the factory air so those I understand.  What about the other two sizes?  Anyone?

15
Originality / Re: Spark Plug Wire routing....?
« on: July 14, 2010, 05:09:02 AM »
My uncle has one, i'll reference it.  Wasn't thinking.  Thanks Bob.

Pages: [1] 2 3 ... 7