CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
September 30, 2014, 11:12:47 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
104969 Posts in 12266 Topics by 4727 Members
Latest Member: Z10 Paceman
* Home Help Search Login Register
  Show Posts
Pages: 1 ... 12 13 [14] 15 16
196  Camaro Research Group Discussion / Maintenance / Question about gas tank on a 69..... on: April 18, 2009, 02:06:00 PM
I have tank out of car. I'm trying to dump out all the gas, but it won't all come out because of the baffles.

Does anybody know how the internal baffles are configured?
Are some attached to bottom and some attched to top of the tank?

BTW: I think it's an aftermarket tank.
197  Camaro Research Group Discussion / Restoration / Re: Engine Paint! on: April 18, 2009, 09:10:41 AM
A lot of people with show cars around here use Bill Hirsch engine enamel
(800-828-2061) .... I don't know if they have a website. They are in NJ.
198  Camaro Research Group Discussion / General Discussion / Re: Z/28 rear-end gearing on: April 11, 2009, 02:57:11 PM
The way I understand it, is that the high-winding 302 is happiest with gear ratios even lower than 3.73 (say 4.10).
199  Site Comments / Discussion / Site Comments/Discussion / Re: Newbie, Veteran, Full Member, etc etc on: April 01, 2009, 05:13:27 PM
YUP.  yup. yup.

LOL
200  Orphans - documentation or VIN-stamped drivetrains - in search of the original cars / 1969 - Orphans / Re: 19L517966 DZ engine on: February 26, 2009, 12:58:21 PM
BIN $4,000....Huh Is that what they go for?
201  Camaro Research Group Discussion / General Discussion / Re: Where can i advertise my hotrod? on: February 23, 2009, 05:11:00 PM
other good one..........
http://www.cars-on-line.com/
202  Camaro Research Group Discussion / General Discussion / Re: 1969 Gas Gage issue on: February 18, 2009, 07:20:02 AM
Sender should be at 90 ohms for a full tank and 0 ohms for empty.
If there was a short it would be reading empty, so that's not the problem.
Try this... Unplug the sender wire (tan) from the harness in the trunk and then turn
on the ignition key, gauge should read past full.
If it doesn't, you have eliminated the sender(it's probably OK), it's either the wiring or the gauge.
203  Camaro Research Group Discussion / Originality / Re: Norwood Camaro with broadcast sheet on: February 10, 2009, 12:46:44 PM
Odd color combo... IMO.
204  Camaro Research Group Discussion / General Discussion / Re: Camaro Performers Magazine Spread! on: January 29, 2009, 07:13:21 AM
Very nice.
205  Camaro Research Group Discussion / Restoration / Re: Help with Differences in Door Glass on: January 14, 2009, 01:12:12 PM
Anyone?
206  Camaro Research Group Discussion / Restoration / Help with Differences in Door Glass on: January 14, 2009, 07:12:30 AM
I went to look at some used replacement door glass for my 69,
and the guy had 2 windows that looked identical except for the
bottom(lower) edge: one had a straight edge and the other had
a curved(arched) edge.

Which would be correct for a 69 coupe???
Thanks.
207  Camaro Research Group Discussion / General Discussion / Re: Having thoughts of selling on: January 02, 2009, 12:11:38 PM
Now is not a good time to be selling, due to the economy, prices are down.
I would keep it as long as you can and wait for a turnaround.
Good Luck.
208  Camaro Research Group Discussion / General Discussion / Re: 1969 glass on: December 17, 2008, 05:51:50 PM
I'm not sure about originality.... but I believe that the windshield is the only "laminated" glass in a car, so it sounds like it could be.
209  Camaro Research Group Discussion / Restoration / Re: rear wheel well drain plugs on: December 15, 2008, 12:38:25 PM
I just bought those from NPD - and they are rubber for both.
210  Camaro Research Group Discussion / General Discussion / Re: 69 Z28 exhaust on: December 09, 2008, 06:54:50 AM
You can buy entire exhaust systems from headers to tailpipes and install yourself.
Pages: 1 ... 12 13 [14] 15 16
Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.081 seconds with 18 queries.