CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 27, 2015, 04:03:08 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
112319 Posts in 12904 Topics by 4940 Members
Latest Member: navan
* Home Help Search Login Register
  Show Posts
Pages: [1] 2 3 4
1  Camaro Research Group Discussion / Originality / Re: 69 Z28 fuel pump on: April 09, 2013, 07:36:59 PM
Steve, great information. I couldn't wait to get out the pump and figure out what I had. Okay here goes. The pump has a Julian code of 087, but the next character seems to be a T. It is smaller than the other characters, so I was wondering if it could be the top of an I which you noted is for 1969. These characters are followed by the 40987. My car is an 05C with an engine code of 0505DZ. The Julian date could work, but I agree with you that the Julian dates were not used in 1969. That 4Th character just puts a thread of doubt in my mind, but not enough conclusive evidence to suggest that it could be a viable possibility. The bottom line is I will be looking for that 40669 pump for the car. Again, thanks Steve for great info!   Bill  Smiley
2  Camaro Research Group Discussion / Originality / Re: 69 Z28 fuel pump on: April 06, 2013, 08:07:16 AM
Thanks for the reply. I guess the only way to document this is for someone to have a survivor or one owner car with the 40987 pump. Hopefully someone out there will be able to provide some info either positive or negative! Good to know that someone else has the same issue.  thanks  Bill  Smiley
3  Camaro Research Group Discussion / Originality / 69 Z28 fuel pump on: April 02, 2013, 06:01:01 PM
I know that this has been discussed before, but i would like to clarify the use of the 40987 fuel pump. I have one on my 57K 69 Z/28, which I thought was original. All of the info I have read states that the 40669 is the only correct pump. I have read several threads on CRG, but was wondering if any new info has surfaced since?  Thanks for any info!!   Bill
4  Camaro Research Group Discussion / General Discussion / Re: Where to Buy on: November 02, 2012, 09:03:35 PM
Bill Mock is the guy to go to as far as I am concerned.  He has been doing them since 1978 and probably has any date you need. Old school guy, no web site,  just a number 918-333-0748. Advertizes in Hemmings all the time. He has done all of my pumps with no issues.  Smiley  Bill
5  Camaro Research Group Discussion / General Discussion / Re: 67 8 track under dash parts on: October 23, 2012, 10:29:24 AM
     Ed's info is interesting. Wonder if it could be a late 67 and 68 thing. Do you know the build date for the car in your pictures? Just wongering.  Bill
6  Camaro Research Group Discussion / Originality / Re: 12/1/67 Stamped DF wheels used in Production? on: October 16, 2012, 06:22:36 PM
        I may have some information for you. I have 2 of the 12/1/7 wheels that you are asking about. One is new and painted grey with a green sticker on the inside, such as a service replacement and the other is a used wheel that has been painted for use on a car. Now that doesn't answer the question as to whether they were only service replacement, but I can verify that my new wheel appears to be a service wheel. Doesn't mean that they weren't used for production during that time period though. Just thought I would throw a little more info into this discussion. I wouldn't think that anyone could say that these wheels were not used in production unless some undisputable documentation was produced. Those wheels should be considered correct for your 01B car IMHO.  But hey, I'm not a judge!
7  Camaro Research Group Discussion / Restoration / Re: Clurch fan rebuild on: August 13, 2012, 06:55:22 PM
Thanks John. Thats what I was hoping to hear! I believe I saw he was going to Corvette Carlisle. I'm going to try and talk to him there.  Thanks again  Bill C
8  Camaro Research Group Discussion / Restoration / Clurch fan rebuild on: August 12, 2012, 09:37:21 PM
I have to get the original clutch fan rebuilt on my 67 Camaro. I found a site for Kirkconnell Corvettes that does the rebuild. Does anyone have any information good or bad on this vendor? Thanks  Bill

9  Camaro Research Group Discussion / Restoration / Re: 67 bench seat parts on: July 18, 2012, 05:05:54 PM
Which parts do you need? I have some of the metal hinge parts for the armrest, but no plastic parts.  Bill
10  Camaro Research Group Discussion / Restoration / Re: 67 floor mount 8 track on: July 18, 2012, 04:48:42 PM
I have a 67 4speed, bench seat car with an under the dash 8 track. There is a good picture in the 67 assembly manual of the bracket and face plate for this type of installation. The bracket does bolt under the dash and the rear of the tape deck rests on the trans tunnel carpet. I have never seen another one installed like this, although I would imagine that some are out there. Good luck finding the bracket and plate.  Bill
11  Camaro Research Group Discussion / Originality / Re: 69z tires on: April 22, 2012, 10:13:02 AM
      I am currently restoring an 05C Norwood Z/28  JL8 with an original SC 200 Spare. I don't have any info as to whether the JL8 option had anything to do with tire selection. I would be interested if anyone has any documentation on the subject.
12  Camaro Research Group Discussion / Decoding/Numbers / Re: 67 Metallic brakes on: December 22, 2011, 11:30:15 PM
Thanks for clarifying the J56 option . When I was doing my 67 Z I asked about the insulators when I had the calipers rebuilt. Lone Star said that they had never seen a Camaro caliper with the insulators and wanted to know if I wanted them put back on. Good move at the time. Now I know that they are correct for my car a it is an original J56 car. Thanks again.   Bill
13  Camaro Research Group Discussion / Decoding/Numbers / Re: Just Bought "Numbers Matching" 67 RS/SS, Did I Make A Mistake? on: September 12, 2010, 06:54:33 PM
Stamping error, plain and simple 
14  Camaro Research Group Discussion / Restoration / Re: original selling dealer emblem rechromed on: May 25, 2010, 09:30:52 PM
Just my two cents, but for potmetal Pauls is the best and they will work with you. If they don't think it can be done correctly they will tell you that before starting.  Ned
15  Camaro Research Group Discussion / General Discussion / Re: Info on Burnish brown 69Z from poland Ohio area on: May 25, 2010, 09:01:59 PM
    Thanks for the reply. I'll keep an ear out for any info on other brown z's from the ohio area. Also I forgot some info on my ifirst post. The time frame for the person Duane Forsyth owning the car was in the 70's and 80's. I have info that he sold the car to the next owner in July of 1980. I also have a sales slip for some parts from a Grach Bros. Speed and Four wheel drive shop in Poland Ohio. Just hoping some of this information will open a door for me to find some info on the car. Thanks again for the responce.  Ned
Pages: [1] 2 3 4
Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.085 seconds with 18 queries.