Topics

31

Decoding/Numbers / Frt Bumper Stamp

« on: August 24, 2011, 01:54:59 AM »

I was taking off my frt bumper brackets and saw this stamped in 4 places on the bumper. Is this something a plating shop used?

Thanks CRG

MM

32

Maintenance / 69 Key on... What dash lights light up?

« on: August 11, 2011, 01:30:52 AM »

Its been awhile guys since I ve had this car running. My first car with console gauges. I need to know in the "ON" or start postion  what lights are on and go out when started

Thanks

Mike

Forgive me

33

General Discussion / Run what you brung @ Cecil COunty dragway Vintage drag racing

« on: July 23, 2011, 04:27:24 PM »

Great short video. Enjoy
http://www.youtube.com/watch?v=daWpqICnR_k&NR=1

Mike

34

Restoration / Front Lower windshield trim clips

« on: July 20, 2011, 01:35:18 AM »

Does anyone have a picture off the clips and how they are spaced on the lower chrome trim molding?

Thanks CRG

Mike

35

Restoration / 69 Low Fuel Light

« on: June 29, 2011, 11:33:05 PM »

Just got around to adding fuel to my car before starting it. Installed new tank ect during restoration. Fuel gauge shows a half tank but the Low Fuel Light is stiil on. Any suggestions on what to start checking?

Thanks CRG

Mike

36

Maintenance / 69 Temp sending unit

« on: June 14, 2011, 12:42:33 AM »

Would anyone know the Standard Products brand part number for a Temp sending unit with gauges? With the stud and nut assy.


Thanks CRG
Mike

37

Maintenance / 12 Bolt spider gear shim

« on: May 23, 2011, 01:22:16 AM »

I was putting in a new axle bearing and was going back with it when the shim fell out from behind one of the spider gears. Is there a way to get the back in without pulling the posi unit?

Thanks
Mike

38

Maintenance / Rear Emer. Brake brackets

« on: May 21, 2011, 10:14:00 PM »

Can anyone tell me how to make the cable stay in the E brake brakets that mount to the mounting plates. ?

Thanks CRG
Mike

39

Restoration / 69 Z/28 spark plug wire looms

« on: March 31, 2011, 12:37:47 AM »

Can anyone tell me which plug wire looms go on what side correctly? A picture would be great.

Thanks CRG

Mike

40

Restoration / 69 clock bulb

« on: March 21, 2011, 12:18:29 AM »

I just got my clock back from being repaired. Went to put it in and the bulb socket wont fit. I have the blade type bulb in it that is oblong and it seems to bottom out. What bulb does it take? Rick's shows a console bulb but mine has a connector with the "push in" not twist bulb. 

Thanks CRG
Mike

41

Maintenance / 69 Headlight switch

« on: March 05, 2011, 09:04:28 PM »

I was having problems with power not getting to my headlights. Got a new switch 7 terminal but what car out of the car is a 8 terminal. Long story short, since putting in the new switch I have power to the headlights now but my dome light which was working with the old switch is now not working. Any idea's ? Also, whats the differance in the 7 and 8 terminal . Do I need an 8 terminal . Help me out.

Non RS Z/28 with U17


Mike

Thanks CRG

42

General Discussion / 69 Red Z/28 RS at the Forge.

« on: January 27, 2011, 05:37:14 PM »

Was just looking through my February issue of Muscle Car Review (page 48) and saw this barn find Garnet Red 69 Z/28 RS. Does anybody have anymore info on this car? Where it came from how many miles . What a great find!

43

Originality / 69 Z/28 fuel line routing

« on: December 24, 2010, 02:19:29 PM »

Does some have a picture of the rubber fuel line that goes from the metal line on the frame to the fuel pump? I just got mine and I know it's not supposed to look like the way I have it. Is there a clip that it holds it to the frame?

Thanks CRG

Mike

44

Originality / 1969 Voltage Reg. Mounting.

« on: November 13, 2010, 06:05:39 PM »

I'm sure this has been covered but I cant find anything on it. I have a 69 02D build date Norwood car . Does it mount with screws or screws and rubber nuts?

Thanks CRG

Mike

45

Maintenance / 69 Rear Wheel Cylinder Plungers

« on: November 07, 2010, 02:09:25 PM »

1969 Rear Wheel Cylinder Plungers?. The little metal T shaped rods that push the shoes out.
Does anyone know where to get these?
Thanks CRG