Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 69z28302

Pages: 1 [2] 3 4 5
16
Maintenance / 69 Taillight sockets
« on: December 18, 2011, 11:15:26 PM »
I'm having trouble with my taillight bulbs not making good contact. Does any know how the terminals come out?

Thx CRG

17
Maintenance / 69 Dist, Vacuum advance
« on: November 26, 2011, 07:43:13 PM »
Hey Camaro enthusiast. I'm having trouble with the vacuum advance when I connect it. The car runs fine disconnected and plugged. Set the timing and connect it it shoots the idle way up . The I adjust the idle down and and bleep the throttle and it very slow to return to idle. Both the Distributor and the carb have been rebuilt by very reputable people (but not the same) .

Any Idea's


Thanks CRG
MIke

18
General Discussion / Anyone have Picture's of the Chicago Show?
« on: November 20, 2011, 01:56:32 PM »
Was wanting to go but couldn't make because of other plans. Heard they were having quite a 69 ZL-1 Camaro line up.


Thanks CRG

Mike

20
Maintenance / 69 Z/28 Tach Stops at 4000 RPM
« on: November 07, 2011, 11:42:50 PM »
Have just recently got the car running. A trip to the muffler shop and to get an alignment. Was out tonight a 'hit it" a couple of times and noticed the tach stopped at 4000 RPM.
Any Ideas?

Thanks CRG

Mike

21
General Discussion / 68 Camaro L-78 Race car on ebay
« on: October 30, 2011, 08:40:13 PM »

22
General Discussion / 69 12 Bolt with 411 gears
« on: October 30, 2011, 04:16:02 AM »
I was going to change the gears in 69 and was wondering with a E-70-15 tire what RPM the engine would turn at 55 MPH and 70 MPH with a 4.11 ratio.

Thanks CRG

Mike

23
General Discussion / Paint Code 63 1969 Z/28 Anyone ever seen one?
« on: October 09, 2011, 01:29:07 PM »
I've only seen a clone copo in this color. Any member's here have a car this color? Paint code 63 Champange.

Thanks
Mike

24
Maintenance / 69 Trunk Lid
« on: September 21, 2011, 11:22:01 PM »
Just put weatherstrip (Metro) on my car now the trunk lid is
jacked up about 1/4 inch or more on the left side. I tried letting it form overnight with no results. Movd the latch in the lid around with no luck. Any Idea's

Thanks CRG

Mike

25
Restoration / 69 Washer Nozzle Finish
« on: September 15, 2011, 10:07:19 PM »
Was wondering if the washer nozzles on the cowl were Silver Zinc

Thanks CRG

Mike

26
General Discussion / 69 Muncie VIN
« on: September 11, 2011, 12:14:29 AM »
Can someone tell me what this trans is out of? It looks like St.Louis plant to me.





Thanks CRG

Mike

28
Restoration / 69 Rear Bumper Guards
« on: September 03, 2011, 09:59:52 PM »
I was trying to install the rear bumper guards on my car and could not get the lower bolts to start. Was going run a tap through them using a 3/8 . Could not even get it to start. I looked at the holes closer and they look to me like there 5/16. 3/8 bolts came with the repop kit.

Can someone tell me what size they are?

Thanks CRG

Mike

29
Restoration / 69 Parking Lamp Restoration
« on: August 29, 2011, 12:42:56 AM »
I think I've seen a topic before on this.  I need to no the process of getting the socket out of the housing without destroying them so I can get them replated.

Thank CRG

Mike

30
Maintenance / Hurst Shifter for a Muncie
« on: August 26, 2011, 12:47:35 AM »
Will a  Hurst shifter for a Muncie also work on a Super T-10 trans? This is for a 69 Camaro application.


Thanks CRG

Mike

Pages: 1 [2] 3 4 5