76
General Discussion / Re: Carlisle Motels
« on: May 19, 2010, 07:07:56 PM »
Sounds good just trying to line up a trailer,mine went missing a while back and I have not replaced it
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
77
General Discussion / Carlisle Motels
« on: May 18, 2010, 09:00:41 PM »
Any ideas what are the best motels for close proximity to the fairgrounds at Carlisle. Never been before but thinking of going to Nationals at end of June
78
General Discussion / Re: gas cap
« on: May 18, 2010, 02:18:38 PM »
Not sure but I think the vent is built into the gas cap.
79
Maintenance / Re: John Z vacuum seyup
« on: April 23, 2010, 12:55:07 AM »
I was able to drive across the border today and buy a couple B28 cannisters. Installing it tonight.
81
Maintenance / setting my timing
« on: April 22, 2010, 07:24:21 PM »
I have tried to set the timing on my 68 z at 4 BTC but the car will not run. I put the timing to 9-10 BTC and the car runs great,also total timing is at 32 at 2900 rpm . Any ideas why it will not run at the recommended 4BTC 
82
Maintenance / Re: John Z vacuum seyup
« on: April 20, 2010, 12:02:01 PM »
Called GM anough at 12 dollars they are only available in the States. It will take 10 days to get a couple shipped up to Canada. Seem cheap en
83
Maintenance / Re: John Z vacuum seyup
« on: April 19, 2010, 09:22:18 PM »
Called around and cannot seem to find a B28 canister. My car has a B16 now and with Johns vacuum setup the car is a lot more streetable for cruising. Thanks all Paul B
84
Maintenance / Re: John Z vacuum seyup
« on: April 19, 2010, 12:36:38 AM »
I will go to the local GM dealer tomorrow and see what I can find out. Thanks for everyones help
85
Maintenance / Re: John Z vacuum seyup
« on: April 18, 2010, 01:06:31 PM »
Thanks I will try and order one
86
Maintenance / Re: John Z vacuum seyup
« on: April 18, 2010, 02:52:50 AM »
Yes I did read it and checked 3 different suppliers. I did not find a store that had any of them listed in stock. I will keep looking. Thanks
87
Maintenance / Re: John Z vacuum seyup
« on: April 17, 2010, 07:34:32 PM »
I am having some difficulty finding the vacuum advance that John Z recommends. Any idea where they can be bought?
88
Maintenance / Re: John Z vacuum seyup
« on: April 17, 2010, 11:29:39 AM »
Yes I am going to the full vacuum from ported. Is the idle at the carb the only thing to readjust? Thanks again
89
Maintenance / Re: John Z vacuum seyup
« on: April 17, 2010, 01:01:56 AM »
Yes if I could remember what I use to know .Have you tried this vacuum hookup.Did it work without any other adjustments to the engine?
90
Maintenance / Re: John Z vacuum seyup
« on: April 17, 2010, 12:31:07 AM »
Thanks for getting that for me