Messages

16

Restoration / Re: carpet install, question

« on: March 25, 2008, 02:05:09 PM »

The bracket should have two rivnuts into the floor

Nope, the bracket has studs and the nuts are on the underside.

  Whoops, sorry about that I was thinking about the rear mount.

17

Restoration / Re: carpet install, question

« on: March 24, 2008, 09:01:47 PM »

The bracket should have two rivnuts into the floor

18

Originality / Re: rocker panel rubber flaps

« on: March 21, 2008, 02:30:22 PM »

My early build 68 did.

19

Restoration / Re: 68 grille picture

« on: November 10, 2007, 04:58:28 PM »

While were on this subject what are the do's & don't of cleaning my factory black 68 SS grille. Like what cleaners not to use, because it looks like the plastic is black no paint.

20

Restoration / Re: metallic factory paint

« on: September 18, 2007, 07:28:35 PM »

no clear

21

Originality / Re: '68 BB Clutch Bellcrank/Z-bar mount point and length ?

« on: September 06, 2007, 01:05:24 PM »

.

 The holes for the z-bar bracket were drilled at the factory when the engine/trans was postioned into the frame. If you use the original holes the z-bar will be at a slight angle and can cause release/alignment problems.

Is this true if so wouldn't this be a good way to tell if a car was a big block car? A person could just measure from the back of the subframe to the mount holes and would know right now .