Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 70lt1z28

Pages: [1] 2 3 ... 6
1
Maintenance / Re: speedometor noise, HELP!!!!
« on: December 01, 2009, 12:11:10 AM »
thanks again

2
Maintenance / Re: speedometor noise, HELP!!!!
« on: November 29, 2009, 04:52:18 PM »
thanks john, any suggestions who to send it to?

3
Maintenance / speedometor noise, HELP!!!!
« on: November 29, 2009, 02:02:50 PM »
i posted last week asking about how to lube a speedo cable and the help here was great. I pulled the cable out of the housing from the top and lubed it completely.  i just buttoned it up and went for a ride.  I am still getting the same racket.  it is not one hundred % of the time  and seems to be mostly between 20 and 50 MPH. when the speedo is making noise the needle is jumping up and down, when the speedo is quiet the needle is smooth and works properly.  any ideas

thanks in advance

4
Maintenance / Re: speedometor cable lube procedure
« on: November 13, 2009, 01:48:29 AM »
thanks alot guys, you have been a big help.  i'm going to tackle the job this weekend.

5
Maintenance / speedometor cable lube procedure
« on: November 12, 2009, 12:30:03 AM »
whats the best way to lube a speedo cable?   i have heard you can pull out the inner part , lube it and put it back. is this true?  can it be pulled out from ther trans or does it have to come out from the top?  any help would be great, right now i am getting an annoying amount of noise coming from the cable. thanks in advance

6
General Discussion / Re: repop spiral shocks same as original GM
« on: July 24, 2009, 11:50:25 PM »
i have them on 2 of my cars and fine to to be fine.  i am not drag racing or anything like that just some cruises and local shows.  so far so good

7
General Discussion / Re: GM Nat's at Carlisle??
« on: July 04, 2009, 12:09:01 AM »
hey chris, i dont know how I did , how about you?  I know by your smile that you must have been better then last year.  i have not  heard about the parts yet, my buddy is sometimes slow to look. I will let you know.

8
General Discussion / Re: GM Nat's at Carlisle??
« on: July 02, 2009, 12:22:21 AM »
i was there, turnout was terrible on friday its really amazing. saturday was much better however still alittle lite IMO. the cars that were there were awsome.

9
Maintenance / Re: Proper brake bleeding procedure for 69 Camaro
« on: June 24, 2009, 01:21:02 AM »
when i put on an original booster and master, i first bench bleed the master and then after installation, i blend the bleeders at the wheels and to my surprise it was perfect the first time.    i did nothing with the metering block or proportioning valve.

10
General Discussion / Re: Engine VIN location - 1970 Z28
« on: June 21, 2009, 12:06:14 PM »
it would be down in the rough cast by the oil filter.  it runs vertical and  its very hard to see in most cases.

11
Originality / T-3 headlight bulbs
« on: June 20, 2009, 12:29:13 PM »
are original T-3s for a 69 camaro dated?   are there any markings or numbers that indicate they came from a car other then a camaro? thanks

12
Originality / Re: 1968 Z RADIATOR OVER FLOW HOSE CLIP
« on: June 13, 2009, 12:32:07 PM »
IMO  and its just that, the hook on the pass side mounting bracket (not the ab clip) could have been used to hang the radiator during painting. again just a thought.

13
Originality / big block radiator over flow hose clip
« on: April 06, 2009, 02:02:44 AM »
anyone know where and how to install an over flow hose  clip on a 69 big block radiator. I already broke one and working on my second.  a picture would be great.  thanks in advance

14
Originality / Re: battery cable numbers
« on: March 13, 2009, 11:41:01 AM »
thanks everyone

15
Originality / Re: battery cable numbers
« on: March 11, 2009, 01:56:47 AM »
thanks again guys, dont know if my info is correct or not, but i just found out that the small block and big block side post cables were not the same numbers, anybody know if this is true or not? any ideas on the big blocks side post cable numbers and where to get them??


Pages: [1] 2 3 ... 6