CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 20, 2014, 06:36:09 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
97283 Posts in 11694 Topics by 4578 Members
Latest Member: ronhill
* Home Help Search Login Register
  Show Posts
Pages: 1 ... 63 64 [65] 66 67 ... 73
961  Camaro Research Group Discussion / General Discussion / Re: How much effect does CE engine code have on value? on: November 24, 2006, 09:41:09 AM
I'd rather have paperwork and a CE than no paperwork and "matching numbers". If someone uses the correct stamps with a gang holder and a virgin factory broached block there would be no way that 99.9% of us would be able to tell if was a restamp or not.
962  Camaro Research Group Discussion / General Discussion / Re: How much effect does CE engine code have on value? on: November 22, 2006, 09:55:30 AM
68's did not have a return line (nor did 67's for that matter)... they either got a single 5/16 or a single 3/8.
963  Camaro Research Group Discussion / General Discussion / Re: How much effect does CE engine code have on value? on: November 20, 2006, 08:02:26 PM
All 68's had single fuel lines.
964  Camaro Research Group Discussion / General Discussion / Re: Pilot Bushing Installation Depth?? on: November 19, 2006, 05:38:54 PM
(Ford SVT engineer)!!
And he drives a 69 Camaro.
965  Camaro Research Group Discussion / Maintenance / Re: Clutch Return Spring Installation with Headers in '69 Camaro Z/28 on: November 15, 2006, 09:40:29 AM
Here is one from the bottom of the car looking at the clutch spring...

Here is another taken from about where a power steering pump would be...
966  Camaro Research Group Discussion / Research Topics & Reports / Re: 68 RS center grille on: November 14, 2006, 05:02:49 PM
There is a yenko.net member with a 68 RS/Z that was unrestored and did have the original grille in 1990.
Lives in CT... I have pics of the car before it was restored and it had the horizontal silver bars in the grille.
I just sent him an email with a link to the thread.

967  Camaro Research Group Discussion / General Discussion / Re: JL8 prices on: November 14, 2006, 04:34:57 PM
8-10k
968  Camaro Research Group Discussion / General Discussion / Re: Car show judging on: November 08, 2006, 01:46:02 PM
Hey 71 Chevelle... your Cowl induction seal is on upside down...
It took me a while to figure it out as well...
Lay the ring on your lap... up side down.... then set the seal on the ring and roll the seal over to the topside... the L in the seal will go into the lip of the cowl ind ring.

You will have to hold one side with an elbow or knee until you get it worked on enough where the tension across the seal will hold it in place.
969  Camaro Research Group Discussion / Decoding/Numbers / Re: Any 67 Norwood 06C (June 3rd week) L48 SS cars? (need your help...) on: November 08, 2006, 01:39:08 PM
I'm not up on small block 67's which engine block would that have had?
970  Camaro Research Group Discussion / Originality / Re: How do members stand on dealer installed undercoating? on: November 08, 2006, 10:15:30 AM
Plastic scrapers or wooden paint stir sticks and kerosene is the best method I have heard of...
It will be alot of hours... I have heard close to 100 or more...
971  Camaro Research Group Discussion / Maintenance / Re: Clutch Return Spring Installation with Headers in '69 Camaro Z/28 on: November 08, 2006, 10:09:23 AM
I reversed the clutch spring and the extension rod... then looked for a direct route where it would not rattle against the header... I will see if I can take a photo of where I ran the rod and spring...
972  Camaro Research Group Discussion / Maintenance / Re: Heater Core on: November 08, 2006, 10:06:11 AM
I replaced one about a 3 months ago with out loosening the fender or inner fender as well.
It was a PITA but then again so would have taking loose the fender.

Inside was the bigger PITA!!!
973  Camaro Research Group Discussion / Originality / Re: 69 Z28 motor / trans authentication on: November 06, 2006, 10:07:47 PM
The vin derivative on the engine and trans should display the same characteristics...
So if one has an inverted number or an out of line number the other should as well or if one has a 3 with a flat top... so should the other.
They were stamped one after the other with the same gang stamp.

Also I have a 618 DZ  casting date is D79 and the nine looks very much like an 8.

974  Camaro Research Group Discussion / General Discussion / Re: 67 REAR ANTENNA OPTION on: November 04, 2006, 05:13:32 PM
No 67's came with a rear spoiler from the factory... 68 and 69 could not have the rear ant with rear spoiler, the spoiler will hit the ant.
975  Camaro Research Group Discussion / General Discussion / Re: Cost of Camaro on: November 04, 2006, 05:11:12 PM
35k..... LOL
A friend just paid 1/2 a million for his building lot on the lake...
The lots on the golf course and the lake are over a mil.
Pages: 1 ... 63 64 [65] 66 67 ... 73
Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.091 seconds with 18 queries.