Show Posts
16
General Discussion / Sheet Metal ?s
« on: June 17, 2006, 01:47:00 AM »
Have 69 x44. Needs both rear quarters, roof, tail panel... I understand the foriegn sheet metal does not always fit well... but are US makers all the same? Going to Carlisle PA next week and would like to know what to look for.
Also is there a manual of some kind that shows or explains body alignment for the gen 1 cars?
Are there any body parts not available? Example: I have never seen the hump over the rear axle or the inside panel of the rear window...or the "Y" shaped panels that run from the floor to the package tray... new to all this and love this site...
hope some of you can help... thanks Wally
Also is there a manual of some kind that shows or explains body alignment for the gen 1 cars?
Are there any body parts not available? Example: I have never seen the hump over the rear axle or the inside panel of the rear window...or the "Y" shaped panels that run from the floor to the package tray... new to all this and love this site...
hope some of you can help... thanks Wally
