CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
September 18, 2014, 08:49:31 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
104534 Posts in 12235 Topics by 4716 Members
Latest Member: Hgtech
* Home Help Search Login Register
  Show Posts
Pages: 1 ... 42 43 [44] 45 46 ... 53
646  Camaro Research Group Discussion / Originality / Re: '69 rear spoilers on: December 29, 2007, 12:26:02 PM
i wonder if there was a definite date, or they just used up what they had. my friends 01A z has the long spoiler.
647  Camaro Research Group Discussion / Originality / Re: UNRESTORED ORIGINAL 68 SS 350 on: December 18, 2007, 09:19:33 PM
the spacing on the vin stamped on the block is too wide.
648  Camaro Research Group Discussion / Originality / Re: 69 front end bolt decode on: December 18, 2007, 04:48:11 PM
what are the headmarkings on the 201's?
649  Camaro Research Group Discussion / Restoration / Re: trunk latch on: December 16, 2007, 09:45:40 PM
mine was partly painted, definately in the car when painted
650  Camaro Research Group Discussion / Restoration / Re: 69 Z28 Power Booster & Master Cylinder Assy on: December 16, 2007, 02:11:13 PM
YOU DONT HAVE TO REMOVE THE BOOSTER. THE 9204 IS EASILY READ WITH A MIRROR AS IT FACES THE FIREWALL. THE JULIAN DATE FACES FORWARD AND IS 1 THROUGH 365. EASY TO FIGURE OUT BY THE PRODUCTION DATE.
GOOD LUCK. PERSONALLY I WOULD RATHER HAVE AN ORIGINAL REBUILT MASTER THAN A REPRO.
651  Camaro Research Group Discussion / Restoration / Re: Well here it is...my new project!!! on: December 07, 2007, 10:47:19 PM
ppg does make it in single stage. i have ordered some to preshoot my 67 rs/ss.
good luck
652  Camaro Research Group Discussion / Maintenance / Re: Muncie M-21 Help on: November 12, 2007, 02:55:16 PM
yup. the brass rings in the three four synchro. it is an easy fix. jerry will do it for you.
653  Camaro Research Group Discussion / Restoration / Re: Carburetor restoration problem on: November 06, 2007, 07:04:26 PM
get the carb back and send it to jerry macneish. period.
654  Camaro Research Group Discussion / Restoration / Re: Dash panels on: November 06, 2007, 07:03:22 PM
there is a guy on ebay uses the name my68z28camaro who says he rechromes the dash clusters. i have bought stuff from him before, but nothing rechromed. look him up and find out what he gets for the job.
655  Camaro Research Group Discussion / Originality / Re: YH wheels on: November 04, 2007, 02:29:29 PM
yes. i have owned the car since 1977.
656  Camaro Research Group Discussion / Originality / Re: YH wheels on: November 01, 2007, 10:28:30 PM
i have 4-21 on my 05A Z
657  Camaro Research Group Discussion / Decoding/Numbers / Re: Does this stamp on the YH wheel look real? on: October 25, 2007, 11:27:40 PM
chris, have you got any april left. two of mine were damaged.
thanks
buddy
658  Camaro Research Group Discussion / General Discussion / Re: need help on lining up front end parts. sway bar, tie rods, idler arm, pitman. on: October 21, 2007, 08:25:30 PM
the pitman arm only goes in one way. the idler arm just bolts in. the only adjustment would be the tie rod ends. tdid you mess with the shims on the upper control arms? thhat would affect the camber. get it so you can drive it, then take it to a good front end shop and let them do it.
659  Camaro Research Group Discussion / Decoding/Numbers / Re: X33 marking behind rear seat enhancement help please.. on: October 21, 2007, 08:21:05 PM
post a pic. if you can see it at all, i wouldnt mess with it.
660  Camaro Research Group Discussion / Restoration / Re: Radiator, recore or replace. on: October 07, 2007, 11:20:31 AM
part of the problem may be that the engine is .60 over. these small blocks dont have a lot of meat on them. definitely recore, dont get rid of the original tanks.
good luck
Pages: 1 ... 42 43 [44] 45 46 ... 53
Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.28 seconds with 18 queries.