Messages

76

General Discussion / Re: Howdy! ...and a Fan blade question

« on: March 10, 2006, 06:35:16 AM »

Thanks!   

I do have the factory assembly manual and checked the "K02" option, it does show part numbers but not "dimensions".  Most of the 5-blade fans on eBay seem to not have an original part number...just and "H" or "W" on them and marked "front".   I am trying to figure out the difference that CRG calls out with the 3" or 3.25" on the fans.

I also see fan clutches on eBay with the part number 3916141 and they claim they are for 68 small block 327 or 350.   Wondering if these will work?  I don't care if the part number is correct so much.  My car is not totally original anyway. 

77

General Discussion / Howdy! ...and a Fan blade question

« on: March 08, 2006, 06:44:28 AM »

Hi folks,

I'm new to this board.  Some of you may remember me, I used to be on the old f-body-classic email list.  Pete Serino is the name and I still have my gorgeous 68 Camaro.   

Got a few questions and I searched the board for an answer but nothing came up.  This relates to an original fan-blade for my car.  I have long since replaced the original fan blade with an aftermarket fan (original got bent to heck when the water pump froze up and went through my radiator. ARgggh!)  Anyway, I am wanting to go back to an original 5-blade fan and fan-clutch (my car has original A/C)  I've been looking for  a fan for a while...a few 5-bladers show up on eBay, but no part numbers or just an "H" on them. 

Any input on where to find a good original fan?   What is the bolt hole spacing of said fan?  I read on CRG site something about 3" diameter for my application and 3.25 for big block or Z28.  What is the dimention between holes center to center?


Anyway, heres a pic of my car.   She made the Dan Lyons 2004 Camaro Calendar!

  

Thanks for your help!

-Pete