CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
November 24, 2014, 12:53:13 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
106527 Posts in 12421 Topics by 4788 Members
Latest Member: capt68
* Home Help Search Login Register
  Show Posts
Pages: 1 ... 67 68 [69] 70 71 ... 75
1021  Camaro Research Group Discussion / Originality / Re: California license letter sequence on: August 11, 2007, 09:13:41 AM
Yep, there were only if I remember, about 50 keys patterns used by GM back then. We had a full set at the gas station, and if someone locked their keys in the car, or took the keys when they left a car for service, we were good to go.

Tom
1022  Camaro Research Group Discussion / Mild Modifications / Re: Aftermarket dash gauge bezels for 1969 Camaro? on: August 10, 2007, 06:07:50 PM
I've been thinking about the Covans piece. Post a pick when your done.

Tom
1023  Camaro Research Group Discussion / Originality / Re: California license letter sequence on: August 10, 2007, 06:04:59 PM
I don't know about CA, but in NJ we can transfer our plates from the old car to the new car at the first registration. If that works in CA it might throw the sequence out a bit.

Tom
1024  Camaro Research Group Discussion / General Discussion / Re: Factory AC upgrade from R-12 to R-134a? on: August 10, 2007, 06:02:28 PM
To charge AC right you need should evacuate the system, and use a set of gauges to measure the charge. However I have seen (not tried) at the Englishtown NJ swap a vendor that sells what he claims is compatible refrigerant at a very reasonable rate. I think it was less than $10 a can. Back in the day we often charged a system with a couple of cans of r12. It usually worked well, and the stuff was a buck or two a can. I should have stocked up.

Tom
1025  Camaro Research Group Discussion / General Discussion / Re: power steering overheating on: August 08, 2007, 03:14:34 AM
Hiw about a ceramic coating on the headers? This should contain more of the exhaust heat.


Tom
1026  Camaro Research Group Discussion / Maintenance / Re: Weird '68 turn signal problem... on: August 05, 2007, 07:27:17 AM
Did you check the flashers? I think turn indicators use a different flasher than the 4-ways. If I'm wrong someone will let it be know.

Good luck,

Tom
1027  Camaro Research Group Discussion / General Discussion / Re: Tailpan blackout on 69' tuxedo black SS396? on: August 01, 2007, 05:29:19 PM
Jerry,

Are you accepting orders for the new 1969 book?

Tom
1028  Camaro Research Group Discussion / General Discussion / Re: Tailpan blackout on 69' tuxedo black SS396? on: August 01, 2007, 06:02:17 AM
http://www.camaros.org/exterior.shtml#BlackoutPaint
1029  Camaro Research Group Discussion / General Discussion / Re: Split rotors on: July 24, 2007, 05:39:06 PM
Years ago I worked in a shop, and the rules were that we could only machine to the minimum size, but we were allowed to put pads on undersized rotors / drums as long as we did not machine past specs. Not to encourage borderline brakes, but if this is a show piece that will be driven lightly on and off the trailer, minor surface issues might be tolerated. (could cause pulling issues)

If it's a driver get them done right. It would be stupid to crash the car because you saved a couple bucks on the brakes.

Tom
1030  Camaro Research Group Discussion / Restoration / Re: oval floor pan plugs on: July 17, 2007, 03:23:33 PM
Not to mention a small puddle now and then.
1031  Camaro Research Group Discussion / General Discussion / Re: L30/M20 is back on Ebay, ...this is NOT an RS/SS... heads up on: July 13, 2007, 11:57:31 AM
Ad calls it an RS/SS 327.

If I recall there were no SS 327's

Decode page says 4P = L48 or L30/M20   SS350 or L30/M20 - Non-SS396/Z28 paint with radius rod

Tom
1032  Camaro Research Group Discussion / General Discussion / Re: Enclosed trailer on: July 13, 2007, 09:31:53 AM
This thread has been giving me that same idea. Expanding the garage would be challenging, and expensive. Would a trailer be a reasonable place to store a car? What additional concerns would there be?

Tom
1033  Camaro Research Group Discussion / Restoration / Re: Rear Seat Filler Panels on: July 11, 2007, 10:18:59 PM
I don't know how correct it is, but Ricks 2006 catalog page 24 shows arm rest panels for 67 deluxe, or 67-69 with fold down, along with upholstery, and filler panels for the same. Filler panels look like the ones in the photo above. That photo was of a 69 with fold down at Carlisle. This is one of the things I was trying to learn about at the show.

Any opinions?

Tom
1034  Camaro Research Group Discussion / Restoration / Re: Rear Seat Filler Panels on: July 11, 2007, 08:44:55 PM
I'd love to see photos of correct components. I bought the seat back with the latch for my 69 at a swap, but need all the additional parts before I can install.

Tom
1035  Camaro Research Group Discussion / Restoration / Re: Rear Seat Filler Panels on: July 11, 2007, 07:46:59 PM
I spoke to someone from Ricks at Carlisle. He told me the rear side panels for my 69 (I am adding the fold down), and convertable panels were the same.
Pages: 1 ... 67 68 [69] 70 71 ... 75
Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.078 seconds with 18 queries.