CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
July 30, 2014, 10:14:35 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
102488 Posts in 12091 Topics by 4669 Members
Latest Member: paulmanta
* Home Help Search Login Register
  Show Posts
Pages: 1 2 3 [4] 5
46  Camaro Research Group Discussion / Research Topics & Reports / Re: 69 decklid emblem holes on: July 24, 2008, 07:24:21 PM
69 NOR, Z28, 05E (shipped June 4 69) trunk lid stamped dated T 20, two sets of emblem holes.
69 NOR, COPO, 06A, factory installed spoilers, (shipped June 24 69) trunk lid stamped date T 17, one set of emblem holes.
47  Camaro Research Group Discussion / Originality / Re: 69Z Alternators - "CZ 4" stamping, what does the "4" mean? on: May 22, 2008, 05:47:32 PM
I have a original 837 with build date of 9-E-23 with stamped CZ with the # 3 under it. I know the stamp is orginal as the alternator was early take off and it has never been restored.
48  Camaro Research Group Discussion / Originality / Re: Speedometer Gear Reduction Unit on: March 22, 2008, 01:47:26 PM
Here is picture of the speedo ratio box from a Ebay auction couple of years ago.











49  Camaro Research Group Discussion / Originality / Re: Spatter Paint on: February 09, 2008, 01:14:39 AM
When I had my 69 trunk sprayed with Larrys paint, we tried to use HVLP paint gun but it kept plugging up the tip. We had to switch to a shotz gun. I can't remember what pressure we used. The shotz gun gave it a more original looking pattern then the paint gun did.
50  Camaro Research Group Discussion / Originality / Re: Gear reduction unit on: December 30, 2007, 02:19:55 PM
Yes, the part number is 6476736, stamped 1:.777, 6476736. This speedo adapter is extremely hard to find. I have only seen two for sale on Ebay and both had sold for more than $700.00.
51  Camaro Research Group Discussion / Decoding/Numbers / Re: Lower steering column bearing on: December 01, 2006, 12:52:03 AM
The parts numbers are  67-68 # 7800528,  69 # 7805365  Theses numbers from my 67-70 GM Camaro parts book.
52  Camaro Research Group Discussion / Restoration / Re: Under dash wiring. on: November 27, 2006, 01:55:09 PM
The main wiring harness goes in front of the steering support rods.
53  Camaro Research Group Discussion / Originality / Re: How do members stand on dealer installed undercoating? on: November 23, 2006, 01:40:22 PM
On the front inner wheelwells, did the factory spray the undercoating on the front wheelhouses before they were assembled to the front fenders, or after the complete front clip was installed on the body ?
54  Camaro Research Group Discussion / Originality / lock nut for the shifter ball on: November 15, 2006, 04:53:51 PM
Did the 69 4 speed shift lever use a lock nut on the shifter ball ? There is no lock nut shown in the AIM or my 67-70 GM camaro parts book. I don't recall  seeing one on any original cars I have looked at over the past years.
55  Camaro Research Group Discussion / Originality / Re: 69 gas cap on: October 26, 2006, 04:31:36 PM
There was one on Ebay Item# 14003493469 that claimed to be a original 69 gas cap. This one is completely round with out the ears on it, the VENTED lettering is raised instead of been stamped. Would this be the assembly line gas cap ?
56  Camaro Research Group Discussion / Originality / 69 gas cap on: October 03, 2006, 12:56:14 PM
Dose anyone know if the original gas cap for the 69 is the same as the GM replacement gas cap ? The AIM shows the gas cap as # 3843698 and the replacement gas cap number is a # 3931449.
57  Camaro Research Group Discussion / Originality / Re: Correct posi tag for rear on '69 on: August 12, 2006, 03:15:43 PM
There is a original 69 posi tag on Ebay right now, item # 160016105260, this is the same tag I have.
58  Camaro Research Group Discussion / Originality / Re: Correct posi tag for rear on '69 on: August 12, 2006, 01:58:38 PM
That tag is incorrect for a 68-69, the correct tag should say (USE POSITRACTION DIFF LUBRICATION ONLY)  The white letters are silk screened on and not cut in to the plastic tag. The hole size is 3/4 inch. Ricks Camaro sells a repo of this tag but the letter fonts are not same as compared to a original tag.
59  Camaro Research Group Discussion / Decoding/Numbers / Re: COPO? on: July 29, 2006, 02:10:09 PM
This car was built 71 cars before my canadian documented copo camaro.
60  Camaro Research Group Discussion / Originality / Re: clutch rod on: July 05, 2006, 02:11:59 PM
All the B/B 4 speed cars used the 1 piece clutch rod with swivel, the S/B 4 speed cars used a 2 piece clutch rod, this is shown in my 67-70 Camaro GM parts book.
Pages: 1 2 3 [4] 5
Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.079 seconds with 18 queries.