CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 20, 2014, 10:59:06 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
97255 Posts in 11694 Topics by 4578 Members
Latest Member: ronhill
* Home Help Search Login Register
  Show Posts
Pages: 1 2 [3] 4 5
31  Camaro Research Group Discussion / Restoration / Re: Correct cowl hood relay screw on: January 01, 2012, 03:02:11 PM
The screw is listed in the AMK catalog with there part # B-12049.
32  Camaro Research Group Discussion / Restoration / Re: 69 Rear Bumper Guards on: September 03, 2011, 05:49:54 PM
The correct bolt size for tail panel is 5\16 NC, the 3/8 bolts are for attaching upper mounting bracket to the bumper guard.
33  Camaro Research Group Discussion / Decoding/Numbers / Re: Rear axle tube codes and engine codes on: August 11, 2011, 06:52:46 PM
My 69 COPO has the rear end with the same build date and engine build date of May 21 69.
34  Camaro Research Group Discussion / Originality / Re: Brake hoses on: August 01, 2011, 06:24:30 PM
The  Raybestos. InLiine Tube hoses are not the same as the original hoses. The original hoses have a square end on the banjo fitting, the InLlne tube and Raybestos hoses have rounded corners on the banjo fitting. The hoses in the auction have the correct square end banjo fitting.
35  Camaro Research Group Discussion / Decoding/Numbers / Re: Latest known 69 Z28 assembly date that had 618 Block? And a few related Q'S on: July 19, 2011, 01:32:50 PM
I use to own a original 69 DZ engine with 618 block with a casting date of A-15-69 and and a assembly build date of V0508DZ.
36  Camaro Research Group Discussion / Research Topics & Reports / Re: Original 67-69 Camaro driveshafts - information requested about your car on: April 25, 2011, 01:49:33 PM
1969
Norwood
06A-Month and week of vehicle assembly
427-Engine
M22-Transmission
49.5-Driveshaft length (measured center of u joint to center of u joint                                                                                                   
3790024- Driveshaft casting number
strap and bolts-Type of attachment to pinion yoke.
BE 0610 G2- Code stamped on front of passenger side axle tube.
N/A-Paint stripes
in-line-Position of the u-joint flanges on each end are in line.
37  Camaro Research Group Discussion / General Discussion / Re: Front Bumper Guard Install on: February 13, 2011, 05:13:38 PM
I checked my 69 NOS front bumper guard kit, instructions show the template from the center line of bumper to the inside edge of the bumper guard is 7 inches.
38  Camaro Research Group Discussion / Decoding/Numbers / Re: Correct date range on: February 03, 2011, 02:14:16 PM
The 2 real 837 dates I have seen that would fit your cars build date is March 24, 69 and April 3, 69.
39  Camaro Research Group Discussion / Restoration / Re: Pressed in bumper nut on: September 20, 2010, 01:51:54 PM
I have a used spare from a old fender extension if you are interested in it.
40  Camaro Research Group Discussion / Originality / windshield washer spray nozzle on: August 06, 2009, 03:40:15 PM
I was looking up the part number for the windshield nozzle in my 67-70 GM camaro parts book, I noticed there were 2 part numbers listed for the nozzle.
# 3886973 -67-69 all except ducted hood.
# 3983947- 69 all with ducted hood.
Does anyone if there was a different nozzle used with the cowl induction hood.
41  Camaro Research Group Discussion / Research Topics & Reports / Re: Gas tank date codes on: July 11, 2009, 07:56:04 PM
Just to add my input, I looked at the tank I removed from my 69 05E, stamped 69  41.
42  Camaro Research Group Discussion / Research Topics & Reports / Re: 69 decklid emblem holes on: July 24, 2008, 07:24:21 PM
69 NOR, Z28, 05E (shipped June 4 69) trunk lid stamped dated T 20, two sets of emblem holes.
69 NOR, COPO, 06A, factory installed spoilers, (shipped June 24 69) trunk lid stamped date T 17, one set of emblem holes.
43  Camaro Research Group Discussion / Originality / Re: 69Z Alternators - "CZ 4" stamping, what does the "4" mean? on: May 22, 2008, 05:47:32 PM
I have a original 837 with build date of 9-E-23 with stamped CZ with the # 3 under it. I know the stamp is orginal as the alternator was early take off and it has never been restored.
44  Camaro Research Group Discussion / Originality / Re: Speedometer Gear Reduction Unit on: March 22, 2008, 01:47:26 PM
Here is picture of the speedo ratio box from a Ebay auction couple of years ago.











45  Camaro Research Group Discussion / Originality / Re: Spatter Paint on: February 09, 2008, 01:14:39 AM
When I had my 69 trunk sprayed with Larrys paint, we tried to use HVLP paint gun but it kept plugging up the tip. We had to switch to a shotz gun. I can't remember what pressure we used. The shotz gun gave it a more original looking pattern then the paint gun did.
Pages: 1 2 [3] 4 5
Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.091 seconds with 18 queries.