76
Originality / Re: Speedometer Gear Reduction Unit
« on: March 22, 2008, 06:47:26 PM »
Here is picture of the speedo ratio box from a Ebay auction couple of years ago.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
77
Originality / Re: Spatter Paint
« on: February 09, 2008, 06:14:39 AM »
When I had my 69 trunk sprayed with Larrys paint, we tried to use HVLP paint gun but it kept plugging up the tip. We had to switch to a shotz gun. I can't remember what pressure we used. The shotz gun gave it a more original looking pattern then the paint gun did.
78
Originality / Re: Gear reduction unit
« on: December 30, 2007, 07:19:55 PM »
Yes, the part number is 6476736, stamped 1:.777, 6476736. This speedo adapter is extremely hard to find. I have only seen two for sale on Ebay and both had sold for more than $700.00.
79
Decoding/Numbers / Re: Lower steering column bearing
« on: December 01, 2006, 05:52:03 AM »
The parts numbers are 67-68 # 7800528, 69 # 7805365 Theses numbers from my 67-70 GM Camaro parts book.
80
Restoration / Re: Under dash wiring.
« on: November 27, 2006, 06:55:09 PM »
The main wiring harness goes in front of the steering support rods.
81
Originality / Re: How do members stand on dealer installed undercoating?
« on: November 23, 2006, 06:40:22 PM »
On the front inner wheelwells, did the factory spray the undercoating on the front wheelhouses before they were assembled to the front fenders, or after the complete front clip was installed on the body ?
82
Originality / lock nut for the shifter ball
« on: November 15, 2006, 09:53:51 PM »
Did the 69 4 speed shift lever use a lock nut on the shifter ball ? There is no lock nut shown in the AIM or my 67-70 GM camaro parts book. I don't recall seeing one on any original cars I have looked at over the past years.
83
Originality / Re: 69 gas cap
« on: October 26, 2006, 09:31:36 PM »
There was one on Ebay Item# 14003493469 that claimed to be a original 69 gas cap. This one is completely round with out the ears on it, the VENTED lettering is raised instead of been stamped. Would this be the assembly line gas cap ?
84
Originality / 69 gas cap
« on: October 03, 2006, 05:56:14 PM »
Dose anyone know if the original gas cap for the 69 is the same as the GM replacement gas cap ? The AIM shows the gas cap as # 3843698 and the replacement gas cap number is a # 3931449.
85
Originality / Re: Correct posi tag for rear on '69
« on: August 12, 2006, 08:15:43 PM »
There is a original 69 posi tag on Ebay right now, item # 160016105260, this is the same tag I have.
86
Originality / Re: Correct posi tag for rear on '69
« on: August 12, 2006, 06:58:38 PM »
That tag is incorrect for a 68-69, the correct tag should say (USE POSITRACTION DIFF LUBRICATION ONLY) The white letters are silk screened on and not cut in to the plastic tag. The hole size is 3/4 inch. Ricks Camaro sells a repo of this tag but the letter fonts are not same as compared to a original tag.
87
Decoding/Numbers / Re: COPO?
« on: July 29, 2006, 07:10:09 PM »
This car was built 71 cars before my canadian documented copo camaro.
88
Originality / Re: clutch rod
« on: July 05, 2006, 07:11:59 PM »
All the B/B 4 speed cars used the 1 piece clutch rod with swivel, the S/B 4 speed cars used a 2 piece clutch rod, this is shown in my 67-70 Camaro GM parts book.
89
Originality / Re: Correct oil pan drain plug for '68 BB
« on: June 23, 2006, 05:47:44 PM »
Thanks John, My 69 Camaro has the later style drain plug. I will be looking for the correct one now.
90
Originality / Re: Correct oil pan drain plug for '68 BB
« on: June 22, 2006, 07:49:51 PM »
Did the 69 BB and SB use this drain plug ?