Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mark x22

Pages: 1 2 3 [4] 5 6 ... 9
47
Originality / Re: Single groove L34 water pump pulley
« on: December 12, 2010, 06:41:49 PM »
Yes

48
Originality / Re: Single groove L34 water pump pulley
« on: December 12, 2010, 06:19:28 PM »
smog pump is under the alternator .

49
General Discussion / Re: factory 1969 12 bolt pinion angle
« on: December 05, 2010, 10:18:51 PM »
No those are my drawings .

50
General Discussion / Re: factory 1969 12 bolt pinion angle
« on: December 04, 2010, 05:06:37 PM »
I redrew the spring in post 10 . When you set it up just get the 6 degree difference between the pinion and the spring perch as shown in the first drawing . Don't worry about the ground or the car that could vary with ride height . Just make it look like the drawing .

51
General Discussion / Re: factory 1969 12 bolt pinion angle
« on: December 04, 2010, 03:17:58 PM »
This is the 2 degrees Rodent was talking about .               

52
General Discussion / Re: factory 1969 12 bolt pinion angle
« on: December 04, 2010, 03:13:57 PM »
With the pinion level which also puts the rear cover mounting surface 90 degrees straight up , the spring perch's point down in the front 6 degrees like the drawings show . With your first question with the perch's level the pinion goes up 6 degrees in the front like in the second drawing

53
Restoration / Re: correct heater hose routing
« on: December 04, 2010, 03:09:05 AM »
This is a 1969 396 does this help ?   

54
General Discussion / Re: factory 1969 12 bolt pinion angle
« on: December 03, 2010, 07:38:58 PM »
same drawing rotated like John said .

55
General Discussion / Re: factory 1969 12 bolt pinion angle
« on: December 03, 2010, 10:59:02 AM »

56
Mild Modifications / Re: 12 Bolt brake line T-Block on 69 Camaro Z28?
« on: November 30, 2010, 11:27:04 PM »
its built into the hose

57
General Discussion / Re: D80 Rear Spoiler Dealer Install?
« on: November 29, 2010, 11:19:38 PM »
forty fourth week

59
Mild Modifications / Re: 10 bolt parts on a 12 bolt?
« on: November 28, 2010, 12:05:24 AM »
10 bolt is 28 spline , 12 bolt is 30 spline

60
General Discussion / Re: Front & Rear Springs ('69 L48 RPO ?)
« on: November 27, 2010, 06:16:18 PM »
The original clamps don't wrap around , they are riveted .The plastic liners don't stick through the spring they go in a stamped recess and you only see the edge . The ends of original springs are stamped thinner  .

Pages: 1 2 3 [4] 5 6 ... 9