121
Restoration / Re: 68 Air Conditioning -Sealing
« on: April 20, 2007, 10:54:42 PM »
i used 3m weatherstrip glue on the radiator where the seal sets on the top plate .
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
122
Restoration / Re: 68 Air Conditioning -Sealing
« on: April 01, 2007, 01:59:32 AM »
the seal covers the bolt if you glue it you cant glue that area . can you scan and post your 1968 AIM page that shows the seal and glue ?
123
Restoration / Re: 68 Air Conditioning -Sealing
« on: March 23, 2007, 01:25:51 AM »
I've seen the same clip on the cowl seal on impalas and i think chevelles . other cars probably have them .
124
Restoration / Re: 68 Air Conditioning -Sealing
« on: March 22, 2007, 10:19:07 PM »
i looked in the yellow pages for foam rubber and found a place that sells it in flat sheets and just cut to fit .it has a skin on one side. i used black 3M weather strip glue, you can get it with self adhesive backing . its been on for years . does you core support have the dimples ? if you drill holes watch out for the condenser underneath them .
125
Restoration / Re: 68 Air Conditioning -Sealing
« on: March 22, 2007, 12:00:10 AM »
this is on a 1969 , the radiator to core support seals i made . if you buy a new top seal use a paper punch to put the holes in ,a razor might leave a corner that can tear .if you look at an original 1967 core support they dont have the dimples for the clip holes .
128
Originality / Re: 69 Headlight washer system T-Valves
« on: December 03, 2006, 02:42:01 PM »
i have one that has a white middle with black ends,built 1c.i dont rember if it came with the car or i already had it. i also have a white y fitting.
129
Originality / Re: 69 Cowl Induction Air Cleaner Question
« on: December 02, 2006, 02:51:37 PM »
my molded insulation is 22 inches across the opening. make sure your seal is not upside down.
130
Originality / Re: 69 Headlight washer system T-Valves
« on: November 16, 2006, 03:24:17 AM »
]
[/url]i didn't notice the windshield check valve . fixed the drawing. also the pump outlets face the drivers side with headlight washers & foward on all others.
