Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - red69

Pages: 1 [2] 3
16
1968 - Orphans / 18L33171? Muncie Transmission Case
« on: June 22, 2020, 09:49:00 PM »
Have had this case laying around the shop for 30+ years believe last digit is a 9. They struck it twice last digit not too clear.

17
Maintenance / Spring in lower radiator hose?
« on: May 12, 2020, 03:27:05 PM »
I purchased a new NAPA (Gates) lower radiator hose for my 69 small block Z-28, it has no spring in the hose. Did factory hoses have a spring? I've always thought it helped prevent collapsing from suction.

18
General Discussion / Stripe Stencil Kits
« on: May 18, 2019, 03:30:23 PM »
Who makes the best correct stripe stencil kit for 69 Z-28?

19
General Discussion / 302 with crossram dyno numbers
« on: January 01, 2019, 12:05:05 AM »
Rebuilt my 69 Z engine this past year. Been in the car for 35 years and I decided to go through it. Only variations from stock specs are .040 overbore, 3927140 off road camshaft, stiffer valve springs, 69 GM crossram, and 1 5/8"primary 3" collector equal length headers. Best numbers were 370 lbs. torque @5700 and 417 H.P. @ 6700.

20
Trans-Am Camaros / Track RPM?
« on: October 16, 2018, 03:02:40 PM »
May have been discussed already searched around and couldn't find anything. What RPM range did the cross ram equipped Camaros see on the typical track. Just curious. Thanks

21
Maintenance / AC R44SX
« on: September 21, 2018, 09:11:25 PM »
I've used R44S in my 69 for years I'm having a hard time getting them. Anyone have any info on the R44SX part #5613591? I have ran across some but can't find info on difference from R44S.

22
Originality / 69 Oil Pressure Line Firewall Hole Location
« on: April 16, 2018, 03:49:13 PM »
Went through the AIM, and searched topics on forum. Not too sure which location 1/2 hole should be drilled. I assume it's drilled in the lower dimple shown in attached photo?

23
Maintenance / Manual Steering box parts
« on: November 13, 2017, 10:45:14 PM »
Looking for a supplier that may have bushings for the sector shaft upper and lower. I've located the rest of the rebuild parts but can't find these. 1969 standard manual steering.

24
Maintenance / Posi Traction Parts?
« on: April 11, 2016, 02:21:58 PM »
I was looking at rebuilding a ten bolt rear end, and didn't seem to come up with any suppliers for posi friction plates etc. Anyone know where to buy them?

25
General Discussion / 1969 Big Block Motor Mount Brackets?
« on: March 10, 2016, 10:38:10 PM »
I have a set of motor mount frame brackets that I bought from GM years ago. One has part #3980941 stamped in it and it measures 1 7/8" to the center line of the mount bolt when laid flat on the bench. The other one is not stamped clearly so I can not read the part # it measures 1 3/8" to the bolt center when flat on the bench. I bought these as a pair and was wondering if anyone could verify these measurements.

26
Decoding/Numbers / 6485891 Air Cleaner Applications
« on: March 25, 2015, 02:43:38 PM »
I have a cowl induction air cleaner assy that I purchased in the 70's part number 6485891. My part book is missing the page that lists it's applications. Would someone with a complete part book look it up please? I believe it is 69 Camaro and some years of Chevelle models.

27
Restoration / 67 radio block off plate
« on: February 20, 2014, 02:58:08 PM »
Looking to remove the radio from a 67. Who sells the best  block off plate?  thanks

28
Decoding/Numbers / Hood Part numbers
« on: December 30, 2013, 01:18:52 AM »
What is the difference between hood part numbers 3938617 and 3938619? Thanks

29
General Discussion / Manuals
« on: December 22, 2010, 10:16:57 PM »
What is the best source for reprinted service and overhaul manuals?
   Thanks Pat

30
Decoding/Numbers / 1111150 Distributer
« on: November 30, 2010, 02:39:54 PM »
I have a part #1111150, date 7D26 distributer. Is it for a 300Hp 350?
    Thanks

Pages: 1 [2] 3