91
General Discussion / Re: Fuel Pump I.D help
« on: April 29, 2021, 02:39:20 PM »
would that include a Z28 302
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
92
General Discussion / Fuel Pump I.D help
« on: April 29, 2021, 02:08:25 PM »
any thoughts on what this pump is. the leaker out of my camaro
93
General Discussion / Re: Carburation Ideas
« on: April 29, 2021, 01:42:38 PM »
Thanks, ahead of you on that.
94
General Discussion / Re: Carburation Ideas, FIXED
« on: April 29, 2021, 12:48:28 PM »
FIXED: FUEL PUMP
Prior to all the tinkering, adjusting and frustrations I tested the psi, 3 different times, had 5-6 pounds..
yesterday, the fuel pump decided to leak, quite badly, around the upper and lower sections thru the ring.
An obvious replacement was done and guess what, NO MORE HESITATION.
Totally a bad coincidence; pump started failing when restored 780 was installed.
I guess the assumption that a mechanical fuel pump is either good or bad has not proven to be.
Was so happy that I drove the car like I just stole it!
Thanks for all the help.
Prior to all the tinkering, adjusting and frustrations I tested the psi, 3 different times, had 5-6 pounds..
yesterday, the fuel pump decided to leak, quite badly, around the upper and lower sections thru the ring.
An obvious replacement was done and guess what, NO MORE HESITATION.
Totally a bad coincidence; pump started failing when restored 780 was installed.
I guess the assumption that a mechanical fuel pump is either good or bad has not proven to be.
Was so happy that I drove the car like I just stole it!
Thanks for all the help.
95
General Discussion / Key Buzzer Fix
« on: April 26, 2021, 05:55:18 PM »
my key buzzer stopped working, the buzzer may not work if the horn does not work as the two are the same relay.
FIX:
remove the steering wheel, the clip and the pieces to get to the turn signal switch
remove the plastic signal switch to get to the key switch
TEST the buzzer by jumping out the two terminals on the bottom of the signal switch assembly. if it buzzes, then it's either bad contacts or the switch itself may be faulty or in need of cleaning or adjustment. if bad it's an easy replacement.
carefully pry up on the two copper connectors on the key buzzer switch and be sure they contact the base of the cam.
Works for me
Now you can enjoy the annoying key in the ignition buzzer!!
FIX:
remove the steering wheel, the clip and the pieces to get to the turn signal switch
remove the plastic signal switch to get to the key switch
TEST the buzzer by jumping out the two terminals on the bottom of the signal switch assembly. if it buzzes, then it's either bad contacts or the switch itself may be faulty or in need of cleaning or adjustment. if bad it's an easy replacement.
carefully pry up on the two copper connectors on the key buzzer switch and be sure they contact the base of the cam.
Works for me
Now you can enjoy the annoying key in the ignition buzzer!!
96
General Discussion / Re: Carburation Ideas
« on: April 17, 2021, 12:11:38 PM »
great input, thanks for getting back to my needs.
maybe for cheap than I should just out change the gas lines
Thanks again everyone.
will be back to my car in about 10 days, I am sure you will being hearing from me again on this post as to how it's going
maybe for cheap than I should just out change the gas lines
Thanks again everyone.
will be back to my car in about 10 days, I am sure you will being hearing from me again on this post as to how it's going
97
General Discussion / Re: Carburation Ideas
« on: April 16, 2021, 11:36:15 PM »
70 primaries...78 secondaries
timing 10 advanced... total 38@2500rpms
28 squirter, will try a 31 as soon as I get back to my car.
timing 10 advanced... total 38@2500rpms
28 squirter, will try a 31 as soon as I get back to my car.
98
General Discussion / Re: Carburation Ideas
« on: April 15, 2021, 08:58:36 PM »
using a pertronics
99
General Discussion / Re: Carburation Ideas
« on: April 15, 2021, 08:19:56 PM »
I am thinking about sending it to Jery, but want to be able to put something on to use while he has it, hopefully using the existing fuel lines,
thanks
Walt
thanks
Walt
101
General Discussion / Re: Carburation Ideas
« on: April 15, 2021, 06:06:40 PM »
yes, not totally sure if I will change or keep putting $$s into it until it's off idle hesitation is gone. I have exhausted everything, including sending it out 2 times to a highly recommended carb shop in New Jersey.
Timing spot on and adjusted with vacuum gauge and checked for leaks.
Just looking for a carb recommendation.
So much help offered here on this site and tried just about all of it.
Timing spot on and adjusted with vacuum gauge and checked for leaks.
Just looking for a carb recommendation.
So much help offered here on this site and tried just about all of it.
102
General Discussion / Carburation Ideas
« on: April 15, 2021, 05:51:07 PM »
If I were to change from my original 780 Holley on my stock 302 69 z, what would be suggested.
Would like to keep it looking proper when air cleaner is on it.
no computer or elect pieces.
Thanks in advance.
Would like to keep it looking proper when air cleaner is on it.
no computer or elect pieces.
Thanks in advance.
103
General Discussion / Re: Thompson Performance PBP H-1 Atomizers
« on: April 07, 2021, 01:53:14 PM »
yes and no changes and now reset back to spec.
like I say it's a very minimal. maybe I am just too picky.
like I say it's a very minimal. maybe I am just too picky.
104
General Discussion / Re: Thompson Performance PBP H-1 Atomizers
« on: April 06, 2021, 08:14:27 PM »
checked and all good on that end.. just ordered a .031 to try that.
will update in a few weeks when I get back to this issue.
will update in a few weeks when I get back to this issue.
105
General Discussion / Re: Thompson Performance PBP H-1 Atomizers
« on: April 06, 2021, 07:59:02 PM »
was much worse earlier, went larger from 25 to 28 squirter and almost completely gone. could a 30 be too large for this, or should I try it and see
thanks
thanks