46
General Discussion / Re: Starter Won't Stop.
« on: January 13, 2022, 10:58:53 PM »
in total agreement ,
thanks again,
Walt
thanks again,
Walt
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
47
General Discussion / Re: Starter Won't Stop.
« on: January 13, 2022, 08:35:37 PM »
Here's one more thing that can be added to a starter not stopping.
A: ried shimming but no changes.
B: pulled the solenoid apart and found that restorer blasted the plunger and powder coated it, loo0ked pretty but not what should be done!
bet I blew out 50 plus beads from inside the plunger. this was causing the plunger not to move freely and to hang up in the solenoid.
All is well, at least for another day in Z land.
Thanks for all the input.
A: ried shimming but no changes.
B: pulled the solenoid apart and found that restorer blasted the plunger and powder coated it, loo0ked pretty but not what should be done!
bet I blew out 50 plus beads from inside the plunger. this was causing the plunger not to move freely and to hang up in the solenoid.
All is well, at least for another day in Z land.
Thanks for all the input.
48
General Discussion / Re: Starter Won't Stop.
« on: January 12, 2022, 11:26:15 PM »
seems to work fine bench testing. engaged and disengages as soon as powered off
49
General Discussion / Re: Starter Won't Stop.
« on: January 12, 2022, 08:02:12 PM »
the spring is in.
50
General Discussion / Starter Won't Stop.
« on: January 12, 2022, 07:22:59 PM »
recently had the oe starter and solenoid rebuilt.
reinstalled it and now when i turn the key to start the starter engages and turns over but will not stop, starter continues to be engaged and turning even with the key off and out...only until I disconnect the battery will it disengage and stop.
this cycle repeats again after reconnecting the battery and turning the key.
boy am I glad I had the coil wire to the cap disconnected.
Is it fair to assume that the solenoid should be the long one without the copper spacer to the motor
the replacement starter works properly.
chased all wiring including ignition switch an and everything tests out good.
Thanks in advance.
reinstalled it and now when i turn the key to start the starter engages and turns over but will not stop, starter continues to be engaged and turning even with the key off and out...only until I disconnect the battery will it disengage and stop.
this cycle repeats again after reconnecting the battery and turning the key.
boy am I glad I had the coil wire to the cap disconnected.
Is it fair to assume that the solenoid should be the long one without the copper spacer to the motor
the replacement starter works properly.
chased all wiring including ignition switch an and everything tests out good.
Thanks in advance.
51
General Discussion / heat riser ?
« on: December 23, 2021, 02:06:25 PM »
have an old gm heat riser with number 6839428. any ideas what it came from.
thanks in advance and Merry Christmas.
thanks in advance and Merry Christmas.
52
General Discussion / Re: Trunk Appearances, what do you like?
« on: October 08, 2021, 04:41:53 PM »
If you would, vote on the poll above,
thanks
thanks
53
General Discussion / Trunk Appearances, what do you like?
« on: October 06, 2021, 08:22:09 PM »
Just curious on how you like to see the trunk at shows and cruises.
54
Restoration / Window felts, fuzzies: 1969 camaro
« on: September 21, 2021, 01:28:23 PM »
1969 camaro with round pieces. Looking to replace the inner and outers this winter, Looking at the RePops.
Any suggestions or opinions on using these, or should I look at a different manufacturer.
Thanks in advance
Any suggestions or opinions on using these, or should I look at a different manufacturer.
Thanks in advance
55
General Discussion / heater control display lighting color
« on: September 14, 2021, 01:23:16 PM »
can't remember if the display color was greenish or white for the heater control panel in a 69 camaro
Thanks in advance.
Thanks in advance.
56
General Discussion / Re: Rumble @55-65 mph
« on: September 03, 2021, 01:52:48 PM »
my bad it is 1".
does any use the clutch fork rod spacer/adapter?
does any use the clutch fork rod spacer/adapter?
58
General Discussion / Re: Rumble @55-65 mph
« on: September 03, 2021, 01:32:29 PM »
Took out some of the free play (about 2.5") in the clutch pedal and left about 1". Improved dramatically. Let's see what happens, winter is coming, too soon, and I most likely will pull the transmission and see what may be the issue, maybe with the excessive free play it messed up the throw out bearing.
Thanks again for all the input on this..
Cruise on!
Thanks again for all the input on this..
Cruise on!
59
General Discussion / Re: Rumble @55-65 mph
« on: September 01, 2021, 02:06:20 AM »
cruised tonight and noticed when I pushed clutch pedal to take out that 1 to 1.25" play, with just a little bit of pressure on it when the play is gone , the rumble all but disappears.
next step would be?
thanks in advance
next step would be?
thanks in advance
60
General Discussion / Re: Rumble @55-65 mph
« on: August 30, 2021, 12:56:20 PM »
things for me to look at here, and the rear view mirror does not vibrate when the rumble is noticable.
thanks so far and will keep you all posted.
thanks so far and will keep you all posted.