Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - WaltZ

Pages: 1 [2] 3 4 5
16
Which Holley Vacuum secondary spring are you running for the 1969 z28 Holley 780 4053 with the standard duntov speced cam.
Looking to have the secondaries fully opened sooner than 5600 rpms under load
thanks in advance
W

17
General Discussion / M-21 Transmission Tag Numbers
« on: April 11, 2022, 01:30:09 PM »
January M-21 Z28 with factory 3:73 Posi which Tag is correct
3946798
or
3946789

thanks in advance

18
General Discussion / Rear Bumper unacceptable fit with tall guards
« on: March 20, 2022, 01:31:29 PM »
any recommendations on who may offer a 69 rear bumper that will conform to the tall bumper guards.
the aftermarket one and the tall guards fit is unacceptable.
it would be good for the short bumperettes, but definitely not the tall.
the guards are good, as they conform nicely to a oem bumper
any advice would be appreciated.
Thanks in advance.
 

19
General Discussion / Short/Tall water pump: Power Steering Brackets
« on: March 10, 2022, 03:07:07 PM »
SBC, for short and tall water pumps, are the power steering brackets the same with the exception of a spacer used with the tall water pump.
Thanks in advance,

20
General Discussion / Speaker Dust Cloth
« on: January 15, 2022, 01:19:15 AM »
looking for 69 Camaro front speaker dust cloth.
what's out there.
thanks in advance
Walt

21
General Discussion / Starter Won't Stop.
« on: January 12, 2022, 07:22:59 PM »
recently had the oe starter and solenoid rebuilt.
reinstalled it and now when i turn the key to start the starter engages and turns over but will not stop, starter continues to be engaged and turning even with the key off and out...only until I disconnect the battery will it disengage and stop.
this cycle repeats again after reconnecting the battery and turning the key.
boy am I glad I had the coil wire to the cap disconnected.
Is it fair to assume that the solenoid should be the long one without the copper spacer to the motor

the replacement starter works properly.
chased all wiring including ignition switch an and everything tests out good.
Thanks in advance.

22
General Discussion / heat riser ?
« on: December 23, 2021, 02:06:25 PM »
have an old gm heat riser with number 6839428. any ideas what it came from.
thanks in advance and Merry Christmas.

23
General Discussion / Trunk Appearances, what do you like?
« on: October 06, 2021, 08:22:09 PM »
Just curious on how you like to see the trunk at shows and cruises.

24
Restoration / Window felts, fuzzies: 1969 camaro
« on: September 21, 2021, 01:28:23 PM »
1969 camaro with round pieces. Looking to replace the inner and outers this winter, Looking at the RePops.
Any suggestions or opinions on using these, or should I look at a different manufacturer.
Thanks in advance

25
General Discussion / heater control display lighting color
« on: September 14, 2021, 01:23:16 PM »
can't remember if the display color was greenish or white for the heater control panel in a 69 camaro
Thanks in advance.

26
General Discussion / Rumble @55-65 mph
« on: August 28, 2021, 01:55:20 PM »
between 55-65 mph there's a rumble with no noticeable vibration.
below and above those speeds it's gone or unnoticeable.
wheels are balanced.
put in neutral at those speeds and idle down motor and still there.
at a loss for this one,
any ideas
thanks in advance

27
General Discussion / Points vs. Electronic Ignition
« on: July 29, 2021, 02:00:06 PM »
Just curious to see what is preferred for all around cruisin in your classic muscle, Points vs. EI.

28
General Discussion / 69 Temp Sending Unit
« on: July 26, 2021, 03:10:22 PM »
Which temp sending unit came with a DZ motor build date 1st week of January 69 with console guages.
threaded stud or slip on type. just curious, mine has the threaded.
Thanks in advance.

29
General Discussion / Power Steering Pump Pressure
« on: July 02, 2021, 07:59:40 PM »
what are the pressures for a 1969 Z28 power steering pump.
mine died and having an issue locating one with the male thread connector.
I have the connector, but the suggested reman will not accommodate that hose connection fitting.
or suggestions on which pump is proper replacement...
Thanks in advance

and everyone have a safe and enjoyable 4th of July

30
General Discussion / Wheels stamped, I wonder what these are from
« on: June 30, 2021, 05:43:21 PM »
4 riveted wheels all coded the same
left of stem: K 17,  right of stem 7 LC
inner rim 15X6,   JK and K-1-7

does anyone know what these could be for.
Thanks in advance

Pages: 1 [2] 3 4 5
anything