Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NickF

Pages: [1]
1
General Discussion / Re: Can-am Engine Blocks
« on: November 27, 2017, 07:50:38 AM »
Here are a couple of pictures of the block... it hasn't been cleaned, so it is a bit dusty...

2
General Discussion / Can-am Engine Blocks
« on: November 14, 2017, 12:29:01 AM »
Hello there! New to the board, and I have a part that I'm not sure what to do with. I have an engine block that was produced for the Maclaren race team in the late 60's or early 70's. It is a Reynolds aluminum block with a casting number 6272785... kind of a unique looking block and it's standard bore, but after reading a little about them I don't want to possibly render it useless by sleeving it.
Does anybody want this thing, or maybe someone could point me in a direction of someone that would want it?

Thanks in advance,

Nick

Pages: [1]
anything