Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hrascoll

Pages: [1] 2
1
Restoration / hood to top header panel gaps
« on: March 12, 2016, 05:32:41 PM »
I have a 67 rs/ss 350. the gaps on both sides and rear of hood(cowl panel) are nicely aligned. the gap on the front of the hood to the top header panel is different from the passenger and drivers side. drivers side is a nice gap of 3/16 but passage side is 3/8. I have seen many Camaros with the same problem. is this normal? if not how do I align it. the  fenders to doors/doors to qtr all look good.

2
Restoration / 67 4 speed reverse switch
« on: December 12, 2015, 11:29:06 PM »
does any body have a picture of a installed reverse switch for a 67. the AIM is not very detailed. I am having trouble with the holes on actuator rod not aligning up.

3
Originality / 67 ac car fast idle switch
« on: December 01, 2015, 04:22:22 AM »
did the 67 350 with factory ac have a fast idle solenoid switch to increase the idle when compressor kicks on? if so, where can I find one? thx

4
Restoration / Re: Welded on Wire/Hose Loom Next to Trim Tag
« on: November 23, 2015, 03:33:14 AM »
my wire loom is missing. anybody know where I can find one.

5
Restoration / Re: wire for light for ac/heater control switch
« on: November 23, 2015, 03:07:01 AM »
sorry I missed a key word to my post "light". it is the light that installs into the switch. I am looking for the color of the wire for the light. thx

6
Restoration / wire for light for ac/heater control switch
« on: November 22, 2015, 06:29:32 PM »
67 Camaro rs/ss with factory a/c.  what color is the wire for the ac/heater control switch? aim shows where to install but I do not see the color of the wire or where it comes from. thx

7
Originality / 1967 compressor vacuum electric switch
« on: November 19, 2015, 04:56:29 AM »
my april built 67 Camaro with factory a/c has a "compressor vacuum electric switch". the part turns on the compressor clutch. I rebuilt it with a new rubber backing and seems to work well.
my question is why would gm use a vacuum electric switch? does the vacuum or lack thereof cycle the clutch. I know when the quad-a-jet goes "WOT" you lose vacuum. so u have vacuum at low rpms or cruse rpms. on acceleration low vacuum thus turning off clutch.

8
Decoding/Numbers / looking for a/c tube 3878598 for 67 camaro
« on: February 05, 2015, 06:13:23 AM »
anyone have or know where I could purchase a/c tube for the expansion valve 3878598. this tube should use a size 8 hose and have a female connection. this part is displayed in the 67 Camaro aim manual at c60 d1 page 213

9
Originality / Re: routing of a/c hoses
« on: February 04, 2015, 04:19:45 PM »
grommet is org and great shape, #8 is repop, hoses are repop, most of clamps are org, poa brackets org, poa is org and has the correct part nbr and Julian date for car. poa was rebuilt/calibrated for 134. I do not have #9 or #10. I was planning to use an extra fender clip for the heater hose that I had laying around. thx

10
Originality / Re: 67 windsheild wiper motor
« on: February 04, 2015, 04:09:35 PM »
los 04A 350, pwr steering, a/c, 4 speed 331 posi fold down seat, console/gauges, deluxe in,. paint code T-2 capri cream/ black vinyl complete all numbers matching. owned since 1976, my first car when I was 16. purchased from cousin who purchased it new in 67. close to end of complete frame off restore began in early 2014. I could never have gotten this far without the wealth of knowledge of this and other Camaro sites. thx guys!

11
Originality / Re: 67 windsheild wiper motor
« on: February 04, 2015, 03:45:41 AM »
here is a pic of the motor and my car

12
Originality / Re: routing of a/c hoses
« on: February 03, 2015, 06:52:50 AM »
very hard to see that, of witch I do not. but I take your word for it and over the bumper extensions they shall go. thank you.

13
Originality / Re: routing of a/c hoses
« on: February 02, 2015, 10:09:25 PM »
I spend have my life in the aim!  it does not show that level of detail.  it gets fuzzy at the bumper/ frame extension. the hoses have to go above or below.

14
Originality / 67 windsheild wiper motor
« on: February 02, 2015, 06:51:27 PM »
I have a 67 rs/ss 350. my wiper motor is part 5045508 type E. black with a yellow stamp of "199 66". I assume the "199" is mid July Julien date of 1966. my car was born 1st week of April 1967. my question is:  could this be the original motor made 10 months before the car? if so then it is worth rebuilding/restoring.

15
Originality / routing of a/c hoses
« on: February 02, 2015, 06:42:25 PM »
I have a 67 rs/ss 350 with factory a/c. when routing the a/c hoses to the condenser, do the hoses go "over or under" the frame extension then into the grommet in the fender.  well. thx

Pages: [1] 2
anything