Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rod396

Pages: [1] 2 3 4
1
Originality / 68 Rally Sport lower side moldings
« on: July 26, 2018, 06:59:41 AM »
On a '68 RS with the lower side moldings, concerning the doors only, I understand that the clips are of the "T" bolt with nut variety, but I am unsure about the ends (front/rear) - are they fastened with the same acorn nuts or are the end clips of the type that have female threads and take the low-profile/flat chrome plated phillips screw typical of most GM products of that era up through the 80's?
Could anyone post a pic showing the end attachments on an original car?
Would greatly appreciate any input on this.
Thank you.

2
Originality / 68 Rally Wheel Date Codes
« on: July 26, 2018, 06:49:33 AM »
I am searching out a set of original Rally wheels for a 68,(09D) and I was wondering what the range would be for the date codes? 90 days? How close to the build date of the car?
Thanks.

3
Originality / Under-Dash Heater Box
« on: June 04, 2018, 02:56:50 PM »
Just want to confirm, on a 68, the under-dash heater box color - is it semi-gloss black, or is it a dark gray?
Thanks for your help.

4
Thank you! I will go and measure mine and see what I have. Thanks again.

5
Hope someone knows the trivia on this. 68 with deluxe interior and fold down seat, the lower armrest panels, were they year-specific? Ashtray size variations? Lower armrest panel itself specific to fold down seat or just deluxe interior?

I have 2 sets - one with large ashtrays, and other with smaller ones- 67,68,69??? Larger ashtrays have ribs on lid.My car is a 68 (September 67 built) and I need to confirm the ash trays as well as any differences between fold down and non fold-down seat.

Also, the length of the thin stainless molding on the cardboard section of the quarter trim panel?

Any help would be appreciated! Thank you.

6
Originality / Re: 68 RS Taillamp Harness
« on: April 24, 2018, 08:36:04 PM »
To Ko lek tor - what is the month/week per your cowl tag?
Thanks.

7
Originality / Re: 68 RS Taillamp Harness
« on: April 23, 2018, 08:45:17 PM »
Thank you!

8
Originality / Re: 68 RS Taillamp Harness
« on: April 19, 2018, 08:34:09 PM »
Can anyone tell me which harness for the taillamps would be correct for my 68 RS- the version with the unplug-able side marker wires or the continuous wiring feed to the side markers?

Thanks

9
Originality / 68 RS Taillamp Harness
« on: April 17, 2018, 08:41:49 PM »
On a 68 RS, is the side marker lamp wiring a separate pigtailed harness, plugging into the taillamp harness on each side, or is it one uninterrupted wiring loom direct to the side marker harness. I have two harnesses, basically identical to each other, which came with my basket case, neither one installed, (backup lamp plugs cut off)one harness ends on each side with a 2-prong plug, the other harness is straight through to the side markers.
Does anyone know which is correct fo 68? Is one possibly a 69?
68 - separate harness just for the side marker lamp?
Or 69?

Thank you

10
Originality / Re: 1969 RS Headlight Bucket Shim
« on: November 22, 2017, 08:14:23 PM »
I was trying to view the photo -?? Can someone direct me on this?
Thanks.

11
Originality / Re: 68 Rear Window Defogger
« on: November 15, 2017, 09:10:19 PM »
Thank you, Ed.

12
Originality / 68 Rear Window Defogger
« on: November 14, 2017, 08:58:25 PM »
On a 68 (sept 67 prod), which would be the correct grille for the rear window defogger? - I have two - one being a rectangle and the other with a curve on one end.

13
Originality / Re: 68 Firebird vs Camaro Dash Grab Bar........
« on: November 07, 2017, 08:59:48 PM »
OK thanks - other than that, are they wider than the Camaro?

14
Originality / 68 Firebird vs Camaro Dash Grab Bar........
« on: November 07, 2017, 03:47:40 PM »
Is the dash grab bar on a 68 Camaro different than that of the same year Firebird? If so, does anybody know what the differences are?

15
Originality / Re: 396 Big Block Water Pump Back Plate, 68
« on: October 30, 2017, 08:28:16 PM »
Thanks for your help! I'll run with the lipped version.

Pages: [1] 2 3 4