Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CR

Pages: [1] 2
1
General Discussion / Re: 1967 L78 4P code car
« on: March 24, 2024, 09:15:04 PM »
Sorry a typo on the Dixie Twister,  it’s an original L-78, 4P.

Regarding SS emblems: A bb was installed in the Z-28 at some point hence SS emblem

2
General Discussion / Re: 1967 L78 4P code car
« on: March 24, 2024, 10:46:41 AM »
Great car. Here is a new 1967 L-79 taken in front of Brooks Chevrolet, Millen, Ga. See window sicker in quarter glass. Johnny Brooks ran the car in Super Stock class and was driven by Huston Platt from Atlanta. It was never titled and sat for years after the dealership closed. It was restored and sold a few years ago. Not sure where it went or if it’s in the L-79 registry. Mr Brooks order the Capri Cream L-79 with heater delete and 4:56 gears.
He also ordered a 67 Butternut Yellow Z-28 with heater delete and 4:88 gears. I have that car now. A friend of mine purchased the Z-28 new and later sold it to another friend. It has been a drag car since 1970 with low mileage. I’m in the slow process of restoring the car now.

3
General Discussion / 1967 Butternut yellow RS
« on: July 17, 2022, 12:50:32 PM »
Anybody know of this car? I sold it in 2011 and trying to run it down. It had 28,000 miles with original paint.

4
General Discussion / Re: 67 Z-28 engine
« on: December 05, 2021, 01:15:48 PM »
Sorry for the late reply James,

The car had a Dana rear end when I purchased it. I found an original 67 12 bolt rear end with the factory right side traction bar bracket that I’ll use. Planning on rebuilding this rear end with 4:88 gears.

Cliff

5
Restoration / Re: Painting the rad support black again
« on: January 09, 2021, 01:16:44 PM »
I’ve used black base and added a flattening agent to the clear urethane (I have the percentage written down somewhere) to replicate the factory sheen. It’s durable and easy to clean

6
General Discussion / Re: 67 Z-28 engine
« on: August 27, 2020, 03:31:15 PM »
Here are some photos

7
General Discussion / Re: 67 Z-28 engine
« on: August 26, 2020, 01:09:51 PM »
Hey James, it did not have the heater block off plates when I purchased the car. The second owner installed a used heater assy. during the time he was driving it on the street. The heater delete plates were gone however, I did purchase a used factory set that I found on eBay. I had asked Jon that question regarding the block offs and You’re right, they were some type of paperboard.

8
General Discussion / Re: 67 Z-28 engine
« on: August 26, 2020, 02:03:13 AM »
The owner was charged for the CP. LOL. He never saw it, it was not in the car at the time of the purchase.

9
General Discussion / Re: 67 Z-28 engine
« on: August 23, 2020, 01:44:21 PM »
James,
The original owner said the car did not come with the Cowl Plenum and the cowl was never cut as you can see from the photo, which is odd.

10
General Discussion / Re: 67 Z-28 engine
« on: August 19, 2020, 11:58:23 PM »
Hey Jon,
I talked to the original owner Mike after I saw you in Chicago, he informed me that he only dropped a valve in the engine without doing any damage to the block. So he sold it with the original engine.
Yes I’ve started the restoration and acquiring parts as I go.

11
General Discussion / 67 Z-28 engine
« on: August 15, 2020, 10:46:08 PM »
In 2017 I found a 67 Z-28 after years of searching that a friend purchased new here in Ga; it sold in 68 to another local friend who took it off of the street, installed a 427 and from there was a dedicated drag car. In the process of doing a full restoration and looking for the original engine which was in great condition when sold.

12
Thanks I’ll check those out.

13
General Discussion / 1967 Camaro factory replacement wiring harness
« on: March 01, 2019, 06:05:46 PM »
I want to replace the engine and headlight wiring harness on my 1967 Z28. What manufacturer makes the best factory correct wiring harness?

14
General Discussion / Re: 1967 Z28 radio heater delete
« on: February 13, 2019, 11:59:13 AM »
Jon
Do you think this cardboard block off would be the same material used on the package trays?
 It looks similar.
Cliff

15
General Discussion / Re: 1967 Z28 radio heater delete
« on: February 12, 2019, 12:55:18 PM »
Great photos. Thanks!

Pages: [1] 2