1
General Discussion / Re: 1969 camaro vinyl top.
« on: December 24, 2024, 03:47:30 PM »
Talked to them yesterday. Maybe I talked to the wrong person. Had a top made by them and they didn't seem interested in helping me out.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
General Discussion / Re: 1969 camaro vinyl top.
« on: December 24, 2024, 02:08:18 AM »
Don't know of any top manufacturer that can give you the correct seem . Have talked to SMS Fabrics and they can't do it. Legends judging allows for the incorrect seem position.
3
General Discussion / Re: 69 Z28 06A battery cables side post Y77
« on: December 20, 2024, 05:51:22 PM »
My 680 negative ,and 683 positive cables ,came on my 06A 69 Z when purchased in 1982. The AIM shows these numbers. The 84 is exactly like the 83 but much thicker . The 84 must have superceded the 83. Also the repro cables show 680 N and 683 positive.
4
General Discussion / Re: 69 Z28 06A battery cables side post Y77
« on: December 15, 2024, 02:53:06 PM »
Doc, Is it possible that the 84 supercedes the 83 ? Aim shows 6297683 . Purchased my car in 82 and it had both original style cables. Can't remember if the positive cable had the 5/16" bolt . The replacement battery had 2 3/8" bolts .
5
General Discussion / 69 Z28 06A battery cables side post Y77
« on: December 14, 2024, 07:11:42 PM »
My O6A Z came with a positive battery cable #3297683AR, same part number as in the AIM. I acquired an #3297684 AS. The 84 also looks correct. Original Delco eye cables. What goes here ?
6
General Discussion / Re: DZ Carburetor base plate notch
« on: October 28, 2023, 02:54:06 PM »
Are you sure it's never been apart ? Thank's
7
General Discussion / Re: DZ Carburetor base plate notch
« on: October 22, 2023, 10:28:15 PM »
Here is the throttle cable bracket.
8
General Discussion / Re: DZ Carburetor base plate notch
« on: October 22, 2023, 10:26:50 PM »
Here is a reference photo. Lower right corner.
9
General Discussion / DZ Carburetor base plate notch
« on: October 21, 2023, 10:39:40 PM »
Does anyone who has a survivor 69 Z28 before June of 69. I would like to know if the carb base plate has a square notch on the drivers side rear mounting leg . This notch was apparently used for the upcoming 70 model year cable accelerator bracket.
10
General Discussion / Factory 69 Z/28 oil pan
« on: August 13, 2023, 02:46:00 PM »
I have 3 versions of 69 Z oil pans. One with hump in the middle (over the counter). The other 2 are factory. The question I have is, when did the reinforced (Ribbed flange) version appear. I removed one from an October 69 302.
Thanks
Thanks
11
General Discussion / Re: Upper dip stick tube painted ?
« on: August 13, 2023, 02:35:54 PM »
Thanks William !
12
General Discussion / Upper dip stick tube painted ?
« on: August 11, 2023, 12:34:39 AM »
Was flint built 69Z upper oil dip stick tube natural or painted ? Thanks
13
1969 - Orphans / 19N519276 Muncie case P9P17
« on: August 11, 2023, 12:29:34 AM »
Out for repair Muncie Case .
14
General Discussion / Re: Small block paint before dress
« on: August 05, 2023, 01:01:18 AM »
Thanks Joe!
15
General Discussion / Small block paint before dress
« on: August 04, 2023, 01:39:36 PM »
What would be the correct Chevy Orange ? Was the balancer and water pump left off at time of paint ? Does the water pump bolts use any washers? Thanks