1
Maintenance / Re: Console Temp Gauge
« on: July 13, 2024, 02:08:03 AM »
I found out this evening that all CHQ temp gauges being made now do have an internal resistor.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Maintenance / Console Temp Gauge
« on: July 12, 2024, 05:23:45 PM »
Does anyone know if the 68-69 Camaro console Temp gauges being made by Classic Headquarters now are internally resisted or not? If they are and don't need the ceramic resistor, I'm assuming the 12 o'clock terminal doesn't get anything connected to it and should be isolated from ground?
3
Maintenance / Re: 69 Pulling To The Right
« on: April 26, 2023, 12:21:53 AM »
I swapped the passenger side tire over to the driver side and driver side tire over to the passenger side. That corrected the minor pulling to the right issue. 😁
4
Maintenance / 69 Pulling To The Right
« on: April 24, 2023, 10:57:43 PM »
Do any of you experienced front alignment guys see anything in this alignment setting on my 69 big block Camaro that would make it pull to the right? All front suspension components are OEM style and complete front end rebuild has 9000 miles on it. Any advice or opinions would be appreciated. Thanks
5
Maintenance / Upper Control Arm Bushing
« on: April 17, 2023, 12:33:21 AM »
I was under my 69 Camaro this evening changing oil and just happened to notice this. What will have to be done to fix this? Will the entire control arm have to come off or is there another way to fix this. Any advice or suggestion will be appreciated. Thanks
6
Maintenance / M22 Throw-Out Bearing
« on: April 15, 2023, 08:04:55 PM »
I need to replace the TO bearing in my 1969 Camaro 396 M22 car. What is the best available? Price is not a problem. I looked at one of the cheap "self aligning" TO bearings at Advance and it felt rough when I rotated it. It also was part plastic, which I really didn't like. It's a lot of trouble changing this TO bearing out and I want the best there is to put back in. Any advice or suggestions would be greatly appreciated.
7
General Discussion / Re: WTBs
« on: September 03, 2022, 03:51:11 AM »
Never mind, I just read in the rules we can't. Sorry
8
General Discussion / WTBs
« on: September 03, 2022, 03:49:50 AM »
Can we post want to buys in here?
9
Restoration / Trunk Torsion Rods
« on: August 25, 2022, 09:30:29 PM »
Does anyone have a picture of the two torsion rods for a 69 Camaro laying on the floor in correct orientation to be installed? Also identified as DS and PS.
10
Originality / Muncie
« on: January 18, 2022, 09:48:18 PM »
69 Camaro SS with a 396. Could an M22 be ordered with a 3.73 gear?
12
Originality / Factory Hub Caps
« on: January 06, 2022, 03:52:13 PM »
How many different styles of plain hub caps were available on a 1969 Camaro ? Are there any threads on here with pictures?
13
Decoding/Numbers / DZ Block
« on: October 26, 2021, 03:24:56 PM »
Is it possible for a 69 Z 010 block to have a date code of A 17 O ?
15
Decoding/Numbers / Steering Box Decal
« on: October 06, 2021, 04:29:46 PM »
Would this BA decal be correct for a 69 SS Camaro 396 Norwood car with power steering? If not, what letters would have been on it, if any?