Messages

1

General Discussion / Re: Help me win the contest!!!

« on: May 09, 2009, 01:14:04 AM »

Done    Good Luck   

2

Decoding/Numbers / Re: can not find vin number on a DZ block

« on: April 02, 2009, 02:36:27 AM »

I do not think the block had been decked. It has been a bracket  motor for at least the last 19 years. We took the engine apart at .030 and bored it to .060 and made it a 355 in 91. The deck is 9.029 pass. and 9.035 driver. I am in no way an expert so anyones help would be appreciated.  Thanks Rich

3

Decoding/Numbers / Re: can not find vin number on a DZ block

« on: March 31, 2009, 01:36:15 AM »

After some very frustrating hours using the yellow crayon and red machinist's dykem I have come up with "perhaps" one number.  I am not sure what else to do.  Any other suggestions or help of any kind would certainly be appreciated.  Attached is the best picture I could take.  Thanks in advance.  Rich

4

Decoding/Numbers / Re: How did Chevy Use the same block for a 350 as a 302 in 1967?

« on: March 18, 2009, 06:09:41 PM »

  Is the 1967 350 rod a different casting or a small jor. rod bored out. ? I know the rod bolts are 11/32 instead of 3/8.

5

Decoding/Numbers / Re: can not find vin number on a DZ block

« on: March 15, 2009, 05:02:17 AM »

Tom-Thanks for the help.  Really appreciate it.

6

Decoding/Numbers / Re: can not find vin number on a DZ block

« on: March 15, 2009, 03:53:43 AM »

I tried that and with a opimas mag head set could not make out anything, but I will try again. I am not computer literate and when I tried to post even one pic it said no more than 150KB ? I am having my wife try but she is not sure either.. This is a Mac for her work, so if anyone has any ideas I would be most grateful...

7

Decoding/Numbers / can not find vin number on a DZ block

« on: March 15, 2009, 03:23:56 AM »

I have looked through the FAQ and the topics but can not find any info on where else the vin # could be besides the front pad and the oil filter housing.. Any suggestions on where to look ?