Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - svtrich

Pages: [1] 2 3
1
I cant believe Im the only person with a LA car? 

2
Originality / how to duplicate correct trunk paint for a 69 LA Z28
« on: July 04, 2015, 05:53:06 AM »
I know the trunk paint on the norwood and la are different. what do I do for my la car
             thanks Richard

3
General Discussion / help holley 4053 Z28 carb not idleing right
« on: May 30, 2010, 05:32:35 AM »
I put 72 jets in the pri.76 in the sec. Im not running the 3030 cam but it dosent idle right.i adjusted the mixture screws but still it isnt right.still idles around 1000rpms
                     Rich

4
General Discussion / Re: Classic Headquarters idler arm? any good?
« on: March 24, 2010, 04:04:36 AM »
Im just affraid that some of this repop stuff may look right but be a piece of junk

                                                     Richard                             

5
Maintenance / where can I buy a manuel steering gear box rebuild kit
« on: March 23, 2010, 04:58:46 AM »
does anyone sell one?
              Richard

6
General Discussion / Classic Headquarters idler arm? any good?
« on: March 23, 2010, 04:43:56 AM »
Are these things any good ? does anyone make a correct quality replacement ?
                                    Richard

7
Im not looking to install the rivets.Im looking for correct looking ball joints for a 69

8
Thank you everyone but its built and done.one more lite coat of paint and in it goes.I ended up using Speed Pro Plasma Moly rings and cleavite bearings
                                               Richard ;D

9
I called Bairs,the ball joints that they use are made by Dana.he couldnt help for Camaro ball joints. :(
                     Richard

10
I talked to Jim at Heartbeatcity.he said he has original type ball joints that will use rivets.MADE IN TURKEY??????????? I think I will pass.if my well falls over because of the ball joint.that wont be cool :'(   I might just use ac delco stuff and see how it goes.
                         

11
after seeing these manifolds.I wonder if I should lightly bead blast it and put a thin coat of clear on it
                      Rich

12
should I get mine media tumbled or just lightly blast it? what did a new one from the factory look like.
                      Richard ;D

13
General Discussion / Re: headers
« on: March 08, 2010, 05:55:26 AM »
check DYNATECH for headers,they sell them at Summit

14
John
do you know a fel pro part # that you can recommend?
                    Richard

15
that doesnt tell me what gasket I should use

Pages: [1] 2 3