Messages

1

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: December 08, 2008, 05:16:52 PM »

Sam, My e-mail address is hrdwrkn1@comcast.net.  THANKS so very much for your help, you have more than gone out of your way. Tom

2

General Discussion / Re: Walter Mitty Challenge

« on: December 07, 2008, 11:37:12 AM »

ccargo, could you check out the 1969 TI ignition wiring diagram thread and see if you could help mrdetail attach or post a wiring diagram to this form. Thanks Tom.

3

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: December 06, 2008, 09:03:29 PM »

Sam, could you e-mail them to me? Thanks, Tom

4

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: December 05, 2008, 12:23:37 PM »

I wish I knew how, I'd tell you. Hopefully someone will reply. Thanks. Tom

5

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: December 01, 2008, 01:16:55 AM »

Zip Products has the parts, but I'm not sure if they have the right ones for a crossram. Tom

6

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: November 27, 2008, 03:50:59 AM »

Thanks Sam.  The write up on this site mentions drilling a 3/4" hole in the firewall for the ignition wire. Looking at some of the pictures the wire appears to have a large grommet made on it go in that 3/4" hole. Is that how you ran the wire to the fuse box, or did you go a different way? Thanks again.  Tom

7

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: November 26, 2008, 04:42:10 AM »

THANKS Sam. Will I have to get one of the circuits to make a Sun tach work with the TI?

Thanks, Tom

8

General Discussion / Re: 1969 TI Ignition wiring diagram

« on: November 25, 2008, 02:05:17 AM »

Sam, it sounds like you have done what I am wanting to do. Do you have a wiring diagram and something to show where to drill the hole in the firewall? I have been able to find new repo dists. and amps. that are quite a bit cheaper than TI Specialties. Thanks for your help!!

9

General Discussion / 1969 TI Ignition wiring diagram

« on: November 22, 2008, 01:42:13 AM »

I was wondering if anyone has a diagram of how to route the wires, and where to drill the hole in the firewall if someone is installing the GM TI ignition? Site has a great write-up on the ignition system, but doesn't list a wiring diagram. Since I am just playing sround with my Camaro, I thought I might try installing one. Thanks.