1
Restoration / Re: 67 AIM 6 B2
« on: June 01, 2010, 05:14:56 PM »
What is an AIM
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
3
General Discussion / Re: Correct SS Exhaust
« on: May 29, 2010, 11:34:05 PM »
I installed Magnaflow on my 69 Z sounds pretty good and not too loud
4
Maintenance / Re: spider gear thrust
« on: May 29, 2010, 11:18:01 PM »
Thanks. That is what I was thinking also
5
Maintenance / Re: hurst shifter problem ?
« on: May 29, 2010, 09:37:40 PM »
Have you changed the linkage adjustment. When i put mine back together I was off a little on the shift gate and it was a little more difficult to feel the reverse spring
6
Maintenance / Re: Floor Jack Lift Points/Jack Stands Placement, 69 Camaro Coupe
« on: May 29, 2010, 09:28:09 PM »
I ran the front up on a set of ramps. then secured front tires to ramps to insure car will not roll back down. I then jacked up th back and placed the stands under the frame just inside the front hanger brackets for the rear springs
7
Maintenance / Re: John Z vacuum seyup
« on: May 29, 2010, 09:22:24 PM »
How do I open the pictures on reply #1
8
Maintenance / Re: spider gear thrust
« on: May 29, 2010, 09:11:11 PM »
I tried prying on the gear but it felt like I was going to damage the washer if I forced it too much under the gear
10
Maintenance / spider gear thrust
« on: May 29, 2010, 06:19:38 PM »
OK. I need some help.
I was changing the rear axle seals (12 bolt posi). I am in the process of putting it back together when I see one of the thrust washers has fallen out from behind the spider gear. Is there a trick to sliding it back in behind the gear without messing the washer?
I was changing the rear axle seals (12 bolt posi). I am in the process of putting it back together when I see one of the thrust washers has fallen out from behind the spider gear. Is there a trick to sliding it back in behind the gear without messing the washer?
11
Originality / differential cover
« on: May 27, 2010, 12:45:07 AM »
Was the differential inspection cover painted on a 1969 12 bolt posi?
13
Originality / Re: 67 & 68 BumbleBee Stripe
« on: March 26, 2010, 06:53:40 PM »
Just learning guys. But whta is a bumble bee and hockey strip
15
Originality / Re: 69 pressure plate bolts
« on: March 26, 2010, 02:03:52 AM »
Thanks Kevin. My old ones had standard locks and the new bolt kit came with out?