Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - z28s4mjg1

Pages: [1]
General Discussion / Re: 1967 Z28 radio heater delete
« on: February 10, 2019, 06:46:02 PM »
There is also a piece of cardboard like material that is taped on the inside of the dash to cover the speaker grille and there is a rubber plug where the radio antenna harness goes through the body near the right side door. 

1968 - Orphans / 1968 Z28 Block 18L320850 V1211MO
« on: July 24, 2018, 12:24:21 AM »
Hi I have this 68 Z28 block 18L320850 VI2IIMO.  The block is standard.

I can send pictures by text or email

Originality / Re: 1967 Small Journal 350
« on: August 26, 2011, 04:18:17 PM »
I was employed at Performance Machine in San Luis Obispo California back in the 70's as a crank grinder.   I recall seeing at least two small journal 350 crankshaft that came from 67 Camaro's. Unfortunately I cannot find my book with the forging numbers in it. But I can validate that one of these came from a co-workers 67 SS-350 which I was familiar with and believe was a fairly early production as it did not have the traction bar on the rear end.  This small journal 350  crank hung hung on the rack the entire time I worked there as no one wanted the small journal cranks that would not fit the 4 bolt main blocks.  During my time there and since then I have I have collected many crankshafts.  The one that I find the most interesting is a cast iron 283 crank with a notch in the flange like 302's have and some steel 283's have.  I bet this will start some discussion! I can post photos.  Is there any information on this site about the special 67 SS-350 dimpled connecting rods.

Pages: [1]