1
General Discussion / Re: DZ Carburetor base plate notch
« on: November 03, 2023, 10:40:58 AM »
Different levels of survivor? Yes carb was apart for new gaskets.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
General Discussion / Re: DZ Carburetor base plate notch
« on: October 26, 2023, 01:29:47 PM »
Original 4053 dated 934....no notch
3
Original Cars and Details / Re: 1969 Camaro L78 M22 - Cortez Silver
« on: March 20, 2023, 06:45:00 PM »
Keep pictures coming all good
4
1969 - Orphans / Re: DZ302 block 9N567605
« on: August 31, 2022, 11:40:12 PM »
Post pic of both stamps
5
Restoration / Re: Rust on exhaust manifolds
« on: June 14, 2022, 05:21:30 PM »
I only ask because I ruined a nice set of manifold's using muretic acid.
6
Restoration / Rust on exhaust manifolds
« on: June 14, 2022, 01:29:59 PM »
Is evaporust safe to use on exhaust manifolds?
7
Original Cars and Details / Re: 1969 Camaro L78 M22 - Cortez Silver
« on: February 03, 2022, 11:06:04 PM »
any chance a few pics from the 400 can be posted?
8
Original Cars and Details / Re: New Section
« on: July 30, 2021, 11:31:40 AM »
This section is very interesting. Love the Z28 cars , need some detail '69 L78 engine pictures.
9
Maintenance / Re: Sleeve in 69 4bolt CE Block
« on: June 04, 2021, 01:11:55 AM »
i bought the long block with the sleeve job already done. Don't have info as to why sleeve was inserted. i took possession with motor apart but apparently it was a running motor when water was left in and frost plug blew out when water froze. This is story that i was told. New plugs inserted but motor never reassembled because car was sold. Last block i did with a sleeve had the step (over 30 yrs ago). This must of been a very old job to have no step, surprised to see the welding, don't know if that was common back then to weld the sleeve to the block? Wondering if anyone out there has put a thicker sleeve with a thin step?
12
Maintenance / Sleeve in 69 4bolt CE Block
« on: June 03, 2021, 03:52:38 AM »
looking for knowledgeable opinions on sleeve job
13
Originality / Re: Service Engines (CE coded)
« on: May 29, 2021, 02:50:20 AM »CE866921 from the best that I can tell...most likely CE966921
15
General Discussion / Re: highly-optioned vs well optioned vs very highly-optioned
« on: March 17, 2021, 08:06:31 PM »Here is my former L-78 RS / SS that Jerry M. thought had a fair amount of options. custom interior, bumper guards, console gagues, 7 k tach. tilt wheel, power steering.comparing to your RS L78, mine is a plain janer which most L78's were