1
1969 - Orphans / Re: 19N685950
« on: November 06, 2018, 02:52:53 PM »
Sorry should have Posted this is A legit DZ 302 V0911DZ
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
4
Originality / Re: Correct Window Molding clips
« on: November 10, 2010, 01:44:04 PM »
Yes, make sure that you check that ALL MOUNTING PINS are in tact, if not have the WELD in type installed. I would not recommend the screw in type replacement as they will fail. The weld in type are easy to install check with your local body shop they should have a Stud/Dent puller Welding gun that can weld them in no time. the studs usually come with this tool and are forgotten about as they are not used as much on Modern cars anymore. There should a BAG of them in the case that the tool comes in Very SMALL Pin studs.
5
Originality / Re: Correct Window Molding clips
« on: November 10, 2010, 02:27:01 AM »
Front windshield clips are RED Oxide, rear are either a"Gun Metal" Color or Black any of the parts houses have them .Yours were probably changed at some point or the originals rusted away and were change with what ever was available
6
General Discussion / Re: New Glass
« on: November 02, 2010, 11:26:36 PM »
Thanks Ron, Happy to help out. Great car, nicely done, a pleasure to work on.
7
General Discussion / Re: New Glass
« on: October 31, 2010, 09:18:11 PM »
Thanks Jeff ... sent you a PM
8
General Discussion / Re: New Glass
« on: October 31, 2010, 06:27:13 PM »
Installed with (Modern) Urethane adhesive Correct type Foam Dam just like the factory did it.I haven't posted on here in a long time ,but I told Ron I would post them for him. Did this over the weekend,not a bad ride to West Point Thanks RonM
Pages: [1] 2