Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ehibs

Pages: [1]
1
Mild Modifications / Re: 396 clearence problem
« on: July 28, 2006, 09:17:35 PM »
thanks ill make shure to check that area! I didnt think about that

2
Mild Modifications / Re: 396 clearence problem
« on: July 09, 2006, 08:58:56 PM »
thats great! The measurements should help me out alot at least I will know for shure if I have the right frame mounts and im ordering new rubber mounts just to eliminate one more thing. I also have a different intake manifold im gonna try that sits alot lower then I think if I get shorter valve covers with the angled back, electric fan that should almost get my problems fixed what do ya think?

3
Mild Modifications / Re: 396 clearence problem
« on: June 11, 2006, 05:54:02 PM »
I forgot to mention that I do have the offset bb fan shroud but the fan sits about a 1/4" to tall and about the same to the driver side. Can you tell by the pix if the upper engine mounts could be the prob?

5
Mild Modifications / 396 clearence problem
« on: June 10, 2006, 11:35:44 PM »
I have a 67 Camaro with a non-factory 396 it did come with a small block though. Im having clearence problems with the ss hood, wiper moter (which some shorter valve covers might fix?), fan not lining up in the fan shroud and i think the distributer will fit but barely! I have the correct bottom engine mounts the top engine mounts are small block but I was told theres no hight difference! I will attach pix and if any one can help that would be great and if you would like me to snap some pix of a more specific area Ill do that! Thanks

Pages: [1]
anything