Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dews 67

Pages: [1]
1
Originality / Re: 67 Sending Unit
« on: February 05, 2006, 12:39:24 AM »
Brian, thanks for the reply.

2
Originality / Re: 67 Sending Unit
« on: February 04, 2006, 01:22:41 AM »
Brian, The rubber sleeve- is it like a foam sleeve like the one on the power steering hose? Do you have a picture? Thanks

3
Originality / 67 Sending Unit
« on: February 03, 2006, 02:36:45 AM »
I ran across this in the Chevrolet Assembly Instructions Book. I have a couple of questions on the supply line from the sending unit. 1, there is a sleeved area with tape on supply line next to the gas tank strap. 2, there is a taped area on fuel line on top of the fuel tank. I haven't seen this before. Was this used on 67's?

4
Restoration / Re: power top motor
« on: January 04, 2006, 12:39:26 AM »
Will try this. Thanks for the tip. Thanks..

5
Originality / Re: Gas Tank Straps+ filler neck
« on: January 04, 2006, 12:29:15 AM »
Thought the filler neck was natural. Gold colored screws. Right? Have a norwood car. Just want to make sure about the gas straps. Dont what to have to change them at a later date to make correct. Thanks..

6
Originality / Gas Tank Straps+ filler neck
« on: January 02, 2006, 11:33:24 PM »
Working on a 67. What color are the gas tank straps? Natural steel or black? Also on the face of the gas filler neck(galvinized piece), is it body color or natural galvinized? Thanks

7
Restoration / power top motor
« on: December 31, 2005, 02:48:54 AM »
Didn't see a topic on this.
I had to put new lines on power top motor on a 67. Sticker on power top calls for type A fluid. They dont make type A anymore. Wonder what trans fluid would be recommended? Thinking type f. Other question is, How do you get the air out of the lines? Only have a small fill hole on the motor. Didn't see a bleeder on the system.  Any tips.. Thanks

8
Restoration / Re: 12 bolt restoration
« on: December 30, 2005, 02:55:48 PM »
Thanks. Just making sure.

9
Decoding/Numbers / Re: Rear axel posi designation
« on: December 30, 2005, 02:30:12 AM »
I dont have the e stamped on my 67 either.  Its a posi also. Enough room between the stamping and the radius bar bracket.  Nothing..

10
Restoration / Re: 12 bolt restoration
« on: December 30, 2005, 02:10:29 AM »
So is the driveshaft flange assembly natural in color? The part that is attached to the pinion gear.

Pages: [1]