Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Miclabel

Pages: [1]
1
General Discussion / Re: block boring
« on: January 26, 2006, 11:52:51 PM »
My 67 283 is .120 over on the bore without sleeving it. Its called a four inch over bore. from what i understand very few castings allow this to take place. Most engines will support .90 but it's not recomended you go over .60. due to cylinder thickness.

2
General Discussion / Re: CRG is Back!
« on: October 20, 2005, 04:54:23 PM »
I had no idea the site was going to be down for the remodel and was actualy concerned it was not going to be back. Nice job on the new forums and i'm glad you're back up.

3
General Discussion / Re: Members from old forum version please post here
« on: October 20, 2005, 04:49:20 PM »
I was miclabel and a member since 2001. Is their a way of getting my old name back? If not i'll survive. :)

Pages: [1]