1
Maintenance / Re: AC plenum valve
« on: July 15, 2021, 07:37:43 PM »
Thx for the photos. Hopefully, I can make this work.
Dale
Dale
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Maintenance / Re: AC plenum valve
« on: July 15, 2021, 01:39:11 AM »
Tim -
Any chance you still have the cowl grill off your car? When I had the bodywork done on my car with the intent of adding factory air, I had a new firewall welded in, but didn't know about the cowl plenum valve and the cut-out needed to install it.
Any chance you - or anyone else reading this - has some accurate measurements for that cut-out on the top of the cowl? I'm going to have to make that cut myself and would like to get it in the right spot and the right size! I've seen one set of photos that give a pretty good picture of where it's located, but if possible, would like some real measurements.
Thanks in advance for any info.
Dale
Any chance you still have the cowl grill off your car? When I had the bodywork done on my car with the intent of adding factory air, I had a new firewall welded in, but didn't know about the cowl plenum valve and the cut-out needed to install it.
Any chance you - or anyone else reading this - has some accurate measurements for that cut-out on the top of the cowl? I'm going to have to make that cut myself and would like to get it in the right spot and the right size! I've seen one set of photos that give a pretty good picture of where it's located, but if possible, would like some real measurements.
Thanks in advance for any info.
Dale
Pages: [1]