Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ric1969

Pages: [1] 2 3 4
1
  I have two 69 Camaros both Van Nuys 1B and 2B does not have the partial Vin stamped by blower motor area.

2
General Discussion / Re: Pistons: Replacement
« on: April 26, 2023, 12:22:44 PM »
 JE pistons they are the same design as the originals and better quality.

3
General Discussion / Re: Interesting period photos.... :)
« on: April 25, 2023, 11:31:48 AM »
 Yes, front and rear spoilers very nice.

4
Maintenance / Re: 69 Pulling To The Right
« on: April 25, 2023, 02:14:58 AM »
 The setting you have is ok, try swap the tires right to left , left to right or another set of tires.

5
General Discussion / Re: Argent Silver/ Krylon dull Aluminum
« on: April 07, 2023, 12:55:20 AM »
 Keep away VHT paint Argent Silver missing green tinting...

6
Originality / Re: Fan Shroud Upper Bracket
« on: June 27, 2022, 11:48:55 AM »
  I have two 69s , both are clip nut Los 01B and 02B

7
Restoration / Re: D80 Spoiler Trunk Lid Sealing Tape
« on: June 03, 2022, 06:54:30 AM »
 Thanks for the info guys, so Lloyd yours is early Los with narrow spoiler and shorter rear stripes ??

8
Restoration / Re: D80 Spoiler Trunk Lid Sealing Tape
« on: June 03, 2022, 02:42:50 AM »
  Lloyd , im confuse with the 69 rally stripes on the narrow spoiler , i thought it would be early 68 rally stripes for early 69... Ric

9
Decoding/Numbers / Re: Caveat Emptor...block stamp
« on: June 03, 2022, 01:57:16 AM »
 AFONEFE , i think that a yellow wire goes to the coil [page 304]...

10
General Discussion / Re: 1969 Z28 with 3:31 posi 124379L515933
« on: May 12, 2022, 11:33:08 AM »
 Looks like it, lots of paint tho ...

11
General Discussion / Re: repoe 14 x 7 steels
« on: April 25, 2022, 04:20:30 AM »
 If the centre bore is correct 2.7677 inches or 70.3 mm and wheel studs 7/16 then it has to be the rims

12
General Discussion / Re: repoe 14 x 7 steels
« on: April 24, 2022, 12:50:34 PM »
 Show us a pics of what you have..

13
You keep coming up with good work James well done.

14
General Discussion / Re: repoe 14 x 7 steels
« on: April 24, 2022, 01:41:25 AM »
 Are you using aftermarket rotors...

15
General Discussion / Re: Caution Fan
« on: April 17, 2022, 01:56:05 AM »
 OK,thanks guys ;D

Pages: [1] 2 3 4
anything