1
Restoration / Re: Reproduction Interior Rear Panel Installation Challenges
« on: October 14, 2019, 10:18:54 PM »
I ended up cutting the back upper part of the panel to get it to fit. The two panels were different
and the driver's side needed to be trimmed. The PUI product was terribly made and the two panels were different sizes.
I would like to see a photo of the panel installed were the trim holds the panel in, if anyone could provide one. Need to see
how the trim fits to the body and panel.
Thanks
and the driver's side needed to be trimmed. The PUI product was terribly made and the two panels were different sizes.
I would like to see a photo of the panel installed were the trim holds the panel in, if anyone could provide one. Need to see
how the trim fits to the body and panel.
Thanks