Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dig383

Pages: [1]
1
General Discussion / gas cap
« on: May 18, 2010, 12:28:00 PM »
Hi Everyone
I just finished a frame off resto on my wife's 67RSSS.
After driving the car a few times I noticed the gas tank
is building pressure! The pressure is so great that the tank pops
when the gas cap is removed! I guess the exhaust heat is causing
the pressure to build. I have a new repop gas cap that allows air in but not out.
Is this normal, if so how does the tank vent?
Thanks fo any ideas.
dig383

2
General Discussion / 67 inner pillar post moldings
« on: March 22, 2010, 09:03:19 PM »
Hi Guys
I'm sure you can help.
Whats the best way to install new inner pillar post moldings?
I have installed a new dash pad and the moldings are very tight.
I'm afraid I will break the moldings with too much force.
This is on a 67 model. Thanks for any ideas.
DIG383

3
General Discussion / hood alignment
« on: February 15, 2010, 07:57:29 PM »
Hi Guys
I am finishing a 3 yr. (amateur)  restoration on my wife's 67RSSS 396.
I have the rear door gaps set about the thickness of a paint stick.
Looks nice. The door to fender gaps slightly larger but close.
The hood to fender gaps look about the same on each sides, about a paint stick.
The front of the hood to the header panel is off about 1/4 in. side to side.
How's the best way to correct this issue?
Thanks

Pages: [1]
anything