Topics

1

General Discussion / 68 Trunk Mat

« on: September 07, 2015, 05:02:06 PM »

Installing a new trunk mat in my 68,I am not sure how to cut were the fuel filler tube is.
My original mat is very deteriated and brittle.
Can some of guys post some pics of your trunk mats,most specifically around fuel filler tube.
Thanks in Advance.

2

Restoration / 68 A6 A/C Compressor Rebuild

« on: December 28, 2014, 10:34:33 PM »

I need to have my original 68 A6 AC Compressor rebuilt and restored to complete my restoration and get the AC working.I am Looking for suggestions on who rebuilds compressors.

3

General Discussion / Dual Exaust or Single Exhaust ?

« on: October 10, 2010, 09:08:00 PM »

Trying to determine which exhaust my 1968 Camaro RS came from the factory with,As usually the original factory Exhaust is long gone and had been replaced with headers and after market mufflers and dual pipes.
I am doing a complete restoration and returning it back to factory specs.
The restoration shop raised the question about the exhaust ,single or dual exhaust.
I do not have the factory build sheet to know what it came factory with.
Would the block numbers (327/275) indicate anything,or what about the Trim Tag ,V.I.N.
I have looked in the AIM and can't totally make sense of it.I have been told that certain holes in the rear frame rails can determine which exhaust it came with.
Any feed back would be greatly Appreciated.

4

Restoration / 68 Deluxe Door Panel Repair

« on: April 10, 2010, 09:08:41 PM »

Wanted to know if anybody has had any exprience in repairing cracks or splits in the arm rest portion of a deluxe door panel ? Or what would be even better if anyone knows of a Vendor who makes the kind of repairs ? Any advice would be greatly appreciated.

5

Originality / 68 Heat Stove Finish

« on: February 17, 2010, 02:05:45 AM »

What is the correct factory finish for  68 327 Heat Stove? Typically most are finished in the color as the exaust manifolds.I do not think this correct becuase the the manifolds were castings and the heat stove were stamped steel.Also the heat stove tube was painted black.
I attached a pic of my engine with heat stove installed.

6

General Discussion / Cool Pic

« on: June 21, 2009, 07:51:33 PM »

Thought Everyone would  enjoy this pic.While my wife and I were out on a test drive in this 2010 Camaro SS,
We ran across Trammel  Rhodes out for a cruise in his all original 1969 Z28.He Followed us back to Lawson Chevrolet
In Jasper Georgia for this cool Photo Op.
And you read it right he followed us back.