Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CVKUEBER

Pages: [1]
1
1968 - Orphans / 8N436508 Muncie trans
« on: November 28, 2012, 06:57:49 PM »
Codes on trans 18N436508    P8E07  3925660 two groove input shaft    Cvkueber@msn dot com

2
1968 - Orphans / 8n377775 POP
« on: May 12, 2009, 06:16:21 PM »
8N377775 I have your protecto plate.

3
Restoration / VINYL TOP
« on: April 28, 2009, 08:47:33 PM »
What type and manufacturer of glue is used to install the vinyl top material on a 69 camaro? Thanks in advance.

4
Restoration / 68 standard grille headlamp mounting.
« on: March 27, 2009, 02:31:03 PM »
I have decided to de-clone my 68 from rs/ss back to original standard grille. Would anyone have a good picture of the welded in brackets on the fender lip that mounts the headlamp bracket so I can fabricate new ones. Since I had originally cut these out and discarded twenty years earlier to convert to r/s.  Or does anyone have good ones for sale? Thanks in advance!

5
Restoration / Tail lamp gaskets 1968
« on: December 09, 2008, 06:21:21 PM »
Looking for taillamp housing to rear body panel gaskets that don't leak for 68 coupe. Has anyone had any luck? GM replacements are long gone.  The ones I have now are soft-seal that soak like a sponge. Thanks in advance.

6
Restoration / 1968 Horns
« on: December 03, 2008, 11:11:25 PM »
Does anyone have good photos of how the horns are mounted on both a 68 standard and r/s car? Closeup pictures would be helpful. The assembly manual is not to clear. Thanks in advance, Cory

7
General Discussion / Jim Crawford 1968 corvette bronze low mile camaro
« on: November 16, 2008, 09:32:18 PM »
Does any one know of this 2700 original ss 350 camaro?  http://www.freestyledigital.com/supersportcamaross1968/

8
Restoration / Corvette bronze paint
« on: November 12, 2008, 10:24:53 PM »
A recent trip to the body shop paint supply shop revealed that I couldn't get my corvette bronze mixed in anything but laquer. I would like to use a PPG products in either a base/clear or enamel/clear. The paint code is OO and the Ditzler # is 22969. Does anyone have any info on the paint mixing in this color? Thanks in advance.

Pages: [1]