Messages

1

General Discussion / Re: Fair Market Value

« on: September 29, 2015, 12:07:02 AM »

Ok, for the *** who thinks I'm holding something back by not posting the 1"x3" very very partial rotten unreadable frail broadcast sheet.@$#% off!
For the rest of you, thanks so much for helping me look for clues as to what this car might have been originally. I thought I would get some answers on this forum and I did. I really hope I didn't waste anyone's time . Especially YOU ***!
Ha ha ha
Got a cash offer for $40k so, it's gone!

2

General Discussion / Re: Fair Market Value

« on: September 27, 2015, 01:15:40 PM »

I'm back
Didn't fall off the earth to all you mo foes who think your fairy comments are funny. Attending mothers funeral!
Anyway, I've already expressed my appreciation to those who honestly helped with my car. I realize it's just another CAMARO and so thanks .
Goodby

3

General Discussion / Re: Fair Market Value

« on: September 24, 2015, 12:57:16 AM »

X33rs, I wasn't referring to the 454 intake. I am referring to all the original parts that were on the 396 that I pulled out of the car.
But thanks anyway

4

General Discussion / Re: Fair Market Value

« on: September 21, 2015, 11:42:49 PM »

What will I find with the cross member other than it being BB specific?

5

General Discussion / Re: Fair Market Value

« on: September 21, 2015, 10:04:47 PM »

maybe its really a six cylinder car and someone cloned it

6

General Discussion / Re: Fair Market Value

« on: September 21, 2015, 12:52:19 PM »

Are there any other indicators that may have transferred to the 454 from original motor. Such as the CZ fan clutch and the deep groove pulleys? Will the original intake or water pump tell me anything

7

General Discussion / Re: Fair Market Value

« on: September 21, 2015, 01:44:25 AM »

Than fan clutch has CZ stamped on it.

8

General Discussion / Re: Fair Market Value

« on: September 20, 2015, 05:43:41 PM »

Car will be for sale at the Oct 18 car show and swap meet in Pamona, CA.

9

General Discussion / Re: Fair Market Value

« on: September 19, 2015, 07:05:41 PM »

Looks like CC3
               38366

10

General Discussion / Re: Fair Market Value

« on: September 19, 2015, 06:30:37 PM »

But, wasn't this tranny used after May also? As mine was born in July? So, sounds like it's been pieced together over the years. I know that the 3.73s are in the rear now so, someone before me had good intentions?I've had the car for 9 years or so and am now willing to part my ways with it (only because of medical issues). If anyone wishes to make a reasonable offer you can PM me.
Appreciate it
Thanks

11

General Discussion / Re: Fair Market Value

« on: September 19, 2015, 01:43:02 PM »

I'm gonna try sending pics
Here it goes

12

General Discussion / Re: Fair Market Value

« on: September 19, 2015, 02:18:33 AM »

I would send pics if I could fig out how to make smaller from my ipad😡

13

General Discussion / Re: Fair Market Value

« on: September 19, 2015, 12:19:55 AM »

So, I removed the screws from that cover on the firewall above the heater box and nothing! Think it was part of an alarm or something? It was a sealed box not a cover .
Anyway I'm going under to get tranny and rear end info.
Watch for pics!

14

General Discussion / Re: Fair Market Value

« on: September 18, 2015, 09:32:30 PM »

I was wondering the same thing?

15

General Discussion / Re: Fair Market Value

« on: September 18, 2015, 01:01:26 PM »

Looks like I'll be crawling under the car to get the tranny codes and rear end codes for y'all 👍