Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Rich F

Pages: [1]
1
Restoration / Re: Subframe
« on: May 27, 2012, 01:52:19 PM »
Any idea on why the z-bar would be angled towards the front of the car on the engine?

2
Restoration / Subframe
« on: May 26, 2012, 03:28:08 PM »
Does anyone know if the cross member and trans mount are offset on a 69 firebird subframe vs a 69 Camaro?

I have not been able to find information on the location of these, just the body mount and radiator mount locations.

I am currently in the process of restoring a 69 396 Camaro and the Engine seems to be to far forward. 
The subframe is out of a 69 Firebird which i was told would work. All the mounting holes to mount the body / radiator were the same.
The motor mounts are in correctly with the taller mount on the drivers side.

The Z bar for the cluth is not straight and is angled towards the front of the car and the driveshaft is short about 1".

Help is greatly appreciated.

Thanks Rich


Pages: [1]